Q-Logic 6140 manual Table C-6. Fibre Channel Driver-Error Log Messages

C – Log Messages Error Log Messages

S

262The iSCSI processor failed firmware initialization.

328The iSCSI processor failed the internal loopback test.

329The iSCSI processor failed the external loopback test.

513The iSCSI processor could not connect with the iSCSI name server (iSNS).

849The iSCSI processor reported that the iSCSI port NVRAM contains invalid data (checksum error).

859 The iSCSI processor reported a link down condition.

928The driver failed to receive a heartbeat from the iSCSI processor for the specified number of seconds.

933The driver timed out an iSCSI processor operation and is aborting the oper- ation.

935 The driver timed out an iSCSI processor mailbox command.

937 The driver timed out while attempting to reconnect with the iSNS.

1056 The driver’s initiator database is full. The driver is capable of storing 1024 iSCSI initiators in its database. Use the CLI or GUI to remove unwanted/unused iSCSI initiators.

1072 The driver’s target database is full. Use the CLI or GUI to remove unwanted/unused iSCSI targets.

Fibre Channel Driver

The following error log messages are common to both Fibre Channel ports, 1 (FC1) and 2 (FC2). They are listed in Table C-6and described in this section. Log messages beginning with #0 denote fibre channel port 1 (FC1) and log messages beginning with #1 denote fibre channel port 2 (FC2).

Table C-6. Fibre Channel Driver—Error Log Messages

ID	Log Messages	No.
106583	#%d: QLUtmReceiveIo: Path invalid/FW No resource count %x	87
106589	#%d: QLIoctlEnable: Adapter disabled	93
106590	#%d: QLIoctlEnable: Initialize FW error	94
106592	#%d: QLIoctlRunDiag: Diagnostic loopback command failed %x	96
	% %x %x
106593	#%d: QLIoctlDisable: Re-initialize adapter failed	97
106803	#%d: QLIsrEventHandler: Link down (%x)	307

C-10 FI0154601-00 C