Q-Logic 6140 manual CLI-Discovery Session-Uni-directional Chap, Click Discovery, Use Initiator add

B – Configuring CHAP Configuring CHAP Using CLI

S

2.Use the initiator add command to add the initiator that is about to do discovery:

a.Enable the CHAP for this initiator.

b.Create a secret (for example, secret_initiator).

c.Use the set chap command to update the CHAP settings of the initiator.

3.Go to the Microsoft iSCSI (MS) Initiator and perform the following steps:

a.Click General.

b.Click Secret (in the middle of the screen). If this is the first time you are setting secrets, reset all secrets.

c.Type the secret (secret_port) that you created in Step 1.

4.Click Discovery.

5.Click Add.

6.Type the address of the iSCSI port of the router.

7.Click Advanced.

8.Select Chap Login Information.

9.Type the secret (secret_initiator) you created in Step 2 into Target Secret.

10.Select Mutual Authentication.

11.Click OK.

12.Click OK. The initiator completes the discovery.

CLI—Discovery Session—Uni-directional CHAP

To configure a single-direction CHAP used during a discovery session:

1.Do not enable CHAP on the ISCSI port.

2.Use Initiator add:

a.Add the initiator that is about to perform the discovery.

b.Enable the CHAP for this initiator.

c.Create a secret (for example, secret_initiator).

d.Use Set Chap to update the initiator’s CHAP settings.

3.Go to the MS Initiator.

4.Click Discovery.

5.Click Add.

B-2 FI0154601-00 C