Q-Logic 6140 manual Cable Devices to the Router, Telnet 10.0.0.1 username guest password

4 – Installation

Installing the SANbox 6140 Router

S

To configure the router using the command line interface:

1.Open a command window according to the type of workstation and connection:

„Ethernet (all platforms): Open a telnet session with the default router IP address and log in to the router with the default account name and password (guest/password):

telnet 10.0.0.1 username: guest password: ********

„Serial – Windows: Open the HyperTerminal application on a Windows platform:

a.From the Windows Start menu, select Programs > Accessories, HyperTerminal > HyperTerminal.

b.Select the connection you created earlier and click OK.

„Serial – Linux: Open a command window and enter the following command:

minicom

2.Open an admin session and enter the commands to setup both iSCSI ports and the management interface. See Appendix A for command descriptions.

QRouter #> admin start Password : ******

QRouter (admin) #> set mgmt

………………………

QRouter (admin) #> set iscsi 1

………………………

QRouter (admin) #> set iscsi 2

………………………

Cable Devices to the Router

Connect cables to the SFP transceivers and their corresponding devices. Devices can have SFP (or SFF) transceivers or gigabit interface converters (GBIC). LC-type duplex fiber optic cable connectors are designed for SFP transceivers, while SC-type connectors are designed for GBICs. Choose the fiber optic cable with the connector combination that matches the device being connected to the router.

4-10 FI0154601-00 C