Q-Logic 6140 manual Connect the Router to AC Power, Configure the Router

A

4 – Installation Installing the SANbox 6140 Router

Connect the Router to AC Power

WARNING!!

This product is supplied with a 3-wire power cable and plug for the user’s safety. Use this power cable in conjunction with a properly grounded outlet to avoid electrical shock. An electrical outlet that is not correctly wired could place hazardous voltage on metal parts of the router chassis. The customer must make sure the outlet is correctly wired and grounded to prevent electrical shock.

You may require a different power cable in some countries because the plug on the cable supplied with the equipment will not fit your electrical outlet. In this case, you must supply your own power cable. The cable must meet the following requirements:

„For 125 Volt electrical service: the cable must be rated at 10 Amps and be approved by UL and CSA.

„For 250 Volt electrical service: the cable must be rated at 10 Amps, meet requirements of H05VV-F, and be approved by VDE, SEMKO, and

DEMKO.

To power up the router, connect the power cord to the power receptacle on the router chassis and to a grounded AC outlet. The router responds in the following sequence:

1.The chassis LEDs (input power, heartbeat, system fault) light up, followed by all port LEDs.

2.After a couple of seconds, the heartbeat and system fault LEDs turn off, while the input power LED remains on. The router is executing the POST.

3.After approximately 45 seconds, the POST completes and the heartbeat LED starts flashing at a one second rate. If an error has occurred, the system fault LED will blink a pattern that indicates the fault reason. For more information about error blink patterns, see page 5-3.

Configure the Router

You can configure the router using the SANsurfer iSCSI/FC Router Manager application or the command line interface (CLI).

The SANsurfer Router Manager provides a Configuration Wizard you can use to configure the GE ports. If either of the router’s GE ports have not been configured (IP address is 0.0.0.0), the Configuration Wizard starts automatically when the SANsurfer first connects with the router. The system uses the information collected in Table 4-2.

FI0154601-00 C 4-9