2 – General Description Chassis Controls

S

Reset and Select Boot Image

You can reset the router using either the primary or secondary boot image:

„Primary Image – To reset the router and select the primary boot image, use a pointed, nonmetallic tool to press and hold the maintenance button until the heartbeat LED flashes once, then release the button. The router will boot from the primary boot image. The boot time is less than one minute.

„Secondary Image – To reset the router and select the secondary boot image, use a pointed, nonmetallic tool to press and hold the maintenance button until the heartbeat LED flashes twice, then release the button. The heartbeat LED flashes twice. The router boots from secondary boot image. The boot time is less than one minute.

Reset IP Address

To reset the router and restore the maintenance port IP address to the default

(10.0.0.1), use a pointed, nonmetallic tool to press and hold the maintenance button until the heartbeat LED flashes six times, then release the button. The router boots and sets the maintenance port to IP address 10.0.0.1. The boot time is less than one minute.

The IP address set by this method is not persistent; to make the change persistent, use the command line interface (CLI) or SANsurfer Router Manager to set the IP address. For more information, see page 7-14and page A-30.

Enable DHCP

To reset the router and configure the maintenance port to use DHCP to acquire its IP address, use a pointed, nonmetallic tool to press and hold the maintenance button until the heartbeat LED flashes seven times, then release the button. The router boots and configures the maintenance port for DHCP. The boot time is less than one minute.

Enabling DHCP by this method is not persistent; to make the change persistent, use the command line interface (CLI) or SANsurfer Router Manager to enable DHCP. For details, see page 7-14and page A-33.

Restore Factory Defaults

To reset the router and restore it to the factory default configuration, use a pointed, nonmetallic tool to press the maintenance button and hold it until the heartbeat LED flashes 20 times, then release the button. The router boots and is restored to the factory defaults. The boot time is less than one minute.

The router does the following when restored to the factory defaults:

„Resets all passwords.

„Resets the maintenance port IP address to 10.0.0.1.

„Disables the iSCSI ports and sets the IP address to 0.0.0.0.

2-4

FI0154601-00 C

Page 32
Image 32
Q-Logic 6140 manual Reset and Select Boot Image, Reset IP Address, Enable Dhcp, Restore Factory Defaults