A Command Reference

The command line interface (CLI) enables you to perform a variety of router management tasks through an Ethernet or serial port connection. This section describes the following:

„Logging on to a SAN Router

„Guest Account (see page A-2)

„Working with SAN Router Configurations (see page A-2)

„Commands (see page A-5)

Logging on to a SAN Router

To log on to a router using Telnet, open a command line window on the workstation and enter the telnet command followed by the router IP address:

#telnet <ip_address>

A Telnet window opens prompting you to log in. Enter an account name and password.

To log on to a switch through the serial port, configure the workstation port with the following settings:

„115200 baud

„8-bit character

„1 stop bit

„No parity

Enter an account name and password when prompted.

FI0154601-00 C

A-1

Page 133
Image 133
Q-Logic 6140 manual Command Reference, Logging on to a SAN Router