7 – SANsurfer iSCSI/FC Router Manager System Tree Window

S

NTP Server Information

Select the third vertical tab on the router’s Information tabbed page to display the NTP Server Information tabbed page.

Figure 7-15 Information Tabbed Page - NTP Server Information

The NTP Server Information tabbed page provides the following parameters:

„NTP Server Radio Buttons – Use these buttons to disable or enable the use of NTP servers to set the router’s date and time.

„NTP Server 1 – Displays the IP address of the first NTP server to be queried by the router when setting its time and date. If your hardware supports IPv6, you may choose the appropriate IP protocol of the NTP server, either IPv4 or IPv6, then enter the IP address using the appropriate notation.

„NTP Server 2 – Displays the IP address of the second NTP server to be queried by the router when setting its time and date. This server is used only if the first NTP server did not respond. If your hardware supports IPv6, you may choose the appropriate IP protocol of the NTP server, either IPv4 or IPv6, then enter the IP address using the appropriate notation.

7-16

FI0154601-00 C

Page 82
Image 82
Q-Logic 6140 manual Information Tabbed Page NTP Server Information