Q-Logic 6140 manual Set Snmp Command, Set snmp, Trapdestinations, Properties

A

A – Command Reference Commands

Set SNMP Command

Configures the general simple network management protocol (SNMP) properties, as well as configuring eight trap destinations.

Authority	Admin session
Syntax	set snmp
	trap_destinations
Keywords	trap_destinations
	Specifies the setting of the trap destinations.
Examples	The following example shows the set snmp command for setting the general
	properties:
	QRouter (admin) #> set snmp
	A list of attributes with formatting and current values will follow.
	Enter a new value or simply press the ENTER key to accept the current
	value. If you wish to terminate this process before reaching the end
	of the list press 'q' or 'Q' and the ENTER key to do so.
	Configuring SNMP :
	-----------------
	Read Community	[	] Public
	Trap Community	[	] Private
	System Location	[	]
	System Contact	[	]
	Authentication Traps (0=Enable, 1=Disable)	[Disabled	]

All attribute values that have been changed will now be saved.

The following example shows configuring an SNMP trap destination:

QRouter (admin) #> set snmp trap_destinations

A list of attributes with formatting and current values will follow.

Enter a new value or simply press the ENTER key to accept the current value. If you wish to terminate this process before reaching the end of the list press 'q' or 'Q' and the ENTER key to do so.

Configuring SNMP Trap Destination 1 :

-------------------------------------

FI0154601-00 C A-35