Q-Logic 6140 manual Chassis Controls, Maintenance Button, Reset a Router

A

2 – General Description Chassis Controls

Chassis Controls

The maintenance button shown in Figure 2-3is the only chassis control. Press this button to reset the router or to recover the router if it becomes disabled.

Figure 2-3 Chassis Controls

Maintenance Button

The maintenance button is a multifunction momentary switch on the front panel. It has the following functions:

„Reset a Router (see page 2-3)

„Reset and Select Boot Image (see page 2-4)

„Reset IP Address (see section page 2-4)

„Enable DHCP (see section page 2-4)

„Restore Factory Defaults (see page 2-4)

Reset a Router

To reset the router, use a pointed, nonmetallic tool to momentarily press and release (less than two seconds) the maintenance button. The router responds as follows:

1.All the chassis LEDs illuminate.

2.After about 2 seconds, the POST begins, turning off the heartbeat and system fault LEDs.

3.When the POST is complete, the power LED is on and the heartbeat LED flashes once per second.

FI0154601-00 C 2-3