Q-Logic 6140 manual CLI-Normal Session-Bi-directional Chap, Use Set Chap

A

B – Configuring CHAP Configuring CHAP Using CLI

6.Type the address of the iSCSI port of the router.

7.Click Advanced.

8.Select Chap Login Information.

9.In Target Secret, type the secret (secret_initiator) you created in Step 2.

10.Click OK.

11.Click OK. The initiator should complete discovery.

CLI—Normal Session—Bi-directional CHAP

To configure a bi-directional CHAP used during a normal session:

1.On the router

a.Enable CHAP on the presented target to which the initiator will login.

b.Create a secret (for example, secret_target).

c.Use Set CHAP.

2.Use the initiator add command to add the initiator that is about to do a normal login:

a.Enable the CHAP for this initiator.

b.Create a secret (for example, secret_initiator).

c.Use the set chap command to update the CHAP settings of the initiator.

3.Go to the MS Initiator and perform the following steps:

a.Click General.

b.Click Secret (in the middle of the screen).

c.If this is the first time you are setting secrets, reset all the secrets.

d.Type the secret (secret_target) that you created in Step 1.

4.Click Targets.

5.Select the target you want to login to.

6.Click Advanced.

7.Select Chap Login Information.

8.Type the secret (secret_initiator) that you created in Step 2 into Target Secret.

9.Select Mutual Authentication.

10.Click OK.

11.Click OK. The initiator completes the normal login.

FI0154601-00 C B-3