Q-Logic 6140 manual List of Tables

A

SANbox 6140 Intelligent Storage Router User’s Guide

7-49 Confirm Changes Dialog Box		7-56
7-50 Security Check Dialog Box		7-56
7-51 Firmware Update Status Dialog Box—Progress		7-57
7-52 Finish Dialog Box (Successful Firmware Update)		7-57
7-53 Device Selection Dialog Box		7-59
7-54 LUN Mapping Dialog Box		7-60
7-55 Confirm Changes Dialog Box		7-61
7-56 Security Check Dialog Box		7-61
7-57 LUN Masking Configuration Status Dialog Box		7-62
7-58 Target Configuration Status Dialog Box		7-62
7-59	Finish Dialog Box	7-63
7-60 Device Selection Dialog Box		7-64
7-61 Select the Initiator for the LUN Presentation Dialog Box		7-65
7-62	Confirm Changes Dialog Box	7-65
7-63	Security Check Dialog Box	7-66
7-64	Target Unmapping Wizard Finish Dialog Box	7-66

	List of Tables
2-1	System Fault LED Blink Patterns	2-2
2-2	Port LEDs	2-5
2-3	Serial Port Pin Identification	2-8
3-1	T1 / DS-1: 1.554 Mbits/Sec	3-4
3-2	T3 / DS-3: 45 Mbits/Sec	3-4
3-3	400 Mbits/Sec	3-5
3-4	OC-1: 50 Mbits/Sec	3-5
3-5	OC-3: 150 Mbits/Sec	3-6
3-6	OC-12 and Above: 621 Mbits/Sec	3-7
4-1	Management Workstation Requirements	4-1
4-2	Pre-installation Checklist	4-4
5-1	System Fault LED Blink Patterns	5-3
7-1	SANsurfer Router Manager Main Window Sections	7-2
A-1	Command Line Completion	A-5
C-1	Application Modules—Informational Log Messages	C-1
C-2	SCSI Driver—Informational Log Messages	C-2
C-3	Fibre Channel Driver—Informational Log Messages	C-3
C-4	Application Module—Error Log Messages	C-4
C-5	iSCSI Driver—Error Log Messages	C-9
C-6	Fibre Channel Driver—Error Log Messages	C-10
C-7	User Modules—Error Log Messages	C-12
C-8	System—Error Log Messages	C-14
C-9	iSCSI Driver—Fatal Log Messages	C-15
C-10	Fibre Channel Driver—Fatal Log Messages	C-17
C-11	System—Fatal Log Messages	C-19
D-1	SNMP Properties	D-1
D-2	SNMP Trap Configuration Parameters	D-2

FI0154601-00 C Page xiii