Q-Logic 6140 CLI-Normal Session-Uni-directional Chap, GUI-Discovery Session-Bi-directional Chap

B – Configuring CHAP Configuring CHAP Using the GUI

S

CLI—Normal Session—Uni-directional CHAP

To configure single-direction CHAP to be used during a normal session:

1.Do not enable CHAP on the presented target.

2.Use the initiator add command:

a.Add the initiator that is about to do a normal login.

b.Enable the CHAP for this initiator.

c.Create a secret (for example, secret_initiator).

d.Use the set chap command to update the CHAP settings of the initiator.

3.Go to the MS Initiator.

4.Click Targets.

5.Select the target you want to login to.

6.Click Advanced.

7.Select Chap Login Information.

8.Type the secret (secret_initiator) that you created in into Target Secret.

9.Click OK.

10.Click OK. The initiator completes the normal login.

Configuring CHAP Using the GUI

The following sections describe the procedure for configuring CHAP using the SANsurfer Router Manager, the graphical user interface (GUI).

GUI—Discovery Session—Bi-directional CHAP

To configure a bi-directional CHAP during a discovery session:

1.On the bridge, enable CHAP for the iSCSI port.

2.Select the port in the left column.

3.Click Advanced Configuration.

4.Select Enable Chap.

5.Type a secret in Chap secret (for example, secret_port).

6.Check to see if the initiator exists on the discovered iSCSI initiators list:

„If the initiator is not part of the discovered iSCSI initiators list, then open the Wizard menu and select Add Initiator Wizard.

„If the initiator is part of the discovered list, then go to Step 10.

B-4 FI0154601-00 C