
A
7 – SANsurfer iSCSI/FC Router Manager System Tree Window
iSCSI Port Information
The iSCSI Port Information area provides the following parameters:
Base Name – Full name assigned to the selected iSCSI port.
Link Status – Identifies the port connection status: Link Up or Link Down.
MAC Address – The MAC address assigned to the port. The MAC address is not changeable.
Actual
Link Rate – Displays the actual link rate, which can be Unknown, 1000 Mbps, 100 Mbps, or 10 Mbps. If the port's configuration or connection has changed, the status may not be current. Click the Refresh icon to display the current status.
Programmed Link Rate – The configured data rate for the port. To configure the data rate, click the
Auto - data rate determined by network attachment
10 Mbps - 10 megabits per second
100 Mbps - 100 megabits per second
1000 Mbps - 1000 megabits per second (1 gigabit per second)
Link Rate Mode – If you selected a specific Programmed Link Rate (not Auto), you can specify one of these modes:
Auto
Half Duplex
Full Duplex
Flow Control – If you selected a specific Programmed Link Rate (not Auto), you can enable or disable flow control.
iSCSI Port Network Settings
The iSCSI Port Network Settings area provides the following parameters:
Port Status – When the port link is up, you can enable or disable the port using this
IPv4 Address – When using an IPv4 address scheme, define the following fields:
IP Address – The IP address to which the port responds. An
|