Q-Logic 6140 manual Snmp Settings, Snmp Trap Receivers

A

7 – SANsurfer iSCSI/FC Router Manager System Tree Window

SNMP Settings

„Read Community – Enter a password that authorizes an SNMP management server to read information from the router. This is a write-only field. The value on the router and the SNMP management server must be the same. The read community password can be up to 32 characters excluding #, semicolon (;), and comma (,). The default is public.

„Trap Community – Enter a password that authorizes an SNMP management server to receive traps. This is a write-only field. The value on the router and the SNMP management server must be the same. The trap community password can be up to 32 characters excluding the number sign (#), semicolon (;), and comma (,). The default is private.

„System Location – Specifies the name of the router location. The name can be up to 64 characters excluding the number sign (#), semicolon (;), and comma (,).

„System Contact – Specifies the name of the person to be contacted to respond to trap events. The name can be up to 64 characters excluding the number sign (#), semicolon (;), and comma (,).

„Authentication Traps – Enables or disables the generation of authentication traps in response to authentication failures.

SNMP Trap Receivers

„Enabled SNMP Trap Receivers – Select this check box to enable the trap receiver fields you can use to specify each IP address, trap port, and trap version. The router can support up to eight trap addresses. For each entry, set the following fields:

„IP Protocol – Select the IP protocol version from the drop-down list box: IPv6 Address or IPv4 Address. The corresponding IP Address field changes to accept the appropriate format.

„IP Address – Specifies the IP address to which the SNMP traps are sent.

„Trap Port – Identifies the port number on which the trap is sent. The default is 162.

„Trap Version – Specifies the SNMP version (1 or 2) with which to format traps.

FI0154601-00 C 7-19