Harman Stove Company TL200 Door Assembly/Installation Tips, Door Glass, Glass Retainer Clips

Page 13

Exception TL200 Wood Stove

Door Assembly/Installation Tips

Door Glass

•Be sure that the door glass is installed in the door with the label, located on the glass, on the external side of the door.

•Rope the glass carefully to insure proper sealing.

•Apply the rope exactly along the edge of the external face of the glass, not overhanging or pressed too far in from the edge.

•Make sharp 90o turns at the corners.

•Overlap the ends of the rope at the upper left or right corners.

Glass Retainer Clips

•Use the glass retainer clips and screws supplied in the door kit.

•Use a 1/8" Allen wrench to tighten the glass clips to cast door with 10-24 x 3/8" screws supplied.

Paw Bolt

•The paw bolt should be turned into the door from the inside approximately 14 turns.

•With the set screw removed, turn the brass elbow onto the paw bolt approximately 5 turns, or until a 1/16" clearance is achieved between the elbow and the door face (make sure to stop on the flat spot of the paw bolt).

•The set screw on the brass elbow must be aligned to contact the flat spot on the paw bolt, then tighten using a 5/32" Allen wrench.

•After attaching the door handle, close and latch the door by turning the handle to the six o'clock position. During this process observe to see that the door rope is being compressed properly.

•If it does not compress, loosen the set screw and turn the paw bolt one additional turn into the door. Repeat as required to ensure a tight seal.

HINGE PINS

 

 

 

 

DOOR

 

 

 

 

 

BRASS HANDLE

 

 

 

HANDLE

 

PAW BOLT

SET

BOLT

GLASS

SCREW

 

 

 

 

WOOD

 

GLASS GASKET

 

HANDLE

4 GLASS

 

 

 

RETAINER

 

 

 

CLIPS

4 GLASS

 

 

 

 

 

 

RETAINER

 

 

 

BOLTS

 

 

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents Harman Exception Wood Stove Installation & Operating ManualIntroduction Table of ContentsSpecifications Specifications Draft OperationFuel DoorsCombustion in your Harman Exception is controlled Combustion Process ControlsReloading Air Control Building and Maintaining the FireBlower Removing Ashes Afterburner ViewportDisposal of Ashes Operating as a FireplaceMaintenance Handle GasketsCreosote Blower optional InstallationOutside Air optional Floor Protection Parallel versus Corner InstallationsClearances Door Glass Door Assembly/Installation TipsGlass Retainer Clips Paw BoltSlots for side shield tabs Install the drive arm Exception Linkage InstallationRemove left side shield Install the top lift arm Exception Linkage Installation, contdRe-attach left side shield Things to CheckException Linkage Installation, contd Venting Chimney ConnectorsWall Pass-throughs Chimney Existing Masonry Chimneys Installing to a Prefabricated ChimneyVenting to a Masonry Chimney Venting to a Masonry Fireplace ChimneyVenting Mobile Homes Moblie Home InstallationsException Parts List Exception TL200 Parts Harman Gold Warranty Harman Gold Warranty

TL200 specifications

The Harman Stove Company TL200 is a standout pellet stove designed to deliver both efficiency and elegance to any home. Recognized for its robust construction and advanced features, the TL200 is a popular choice among homeowners looking to maximize heat while minimizing environmental impact.

One of the main features of the TL200 is its high-efficiency pellet burning capability. The stove boasts an impressive EPA certification, which means it meets strict environmental standards for emissions. This is essential not only for regulatory compliance but also for residents who are mindful of their carbon footprint. The stove efficiently converts pellets into heat, with low emissions that contribute to cleaner air quality.

The TL200 incorporates innovative technology to ensure optimal performance. It comes equipped with an intuitive digital control panel, allowing users to easily adjust the heating output according to their needs. This feature is complemented by an automatic igniter that takes the hassle out of starting the stove. With a programmable thermostat, homeowners can maintain their desired temperature effortlessly, leading to energy savings and enhanced comfort.

Another notable characteristic of the TL200 is its large hopper capacity. The stove is designed to hold a substantial amount of pellets, providing extended burn times. This means less frequent reloading, allowing for uninterrupted heating during those cold winter months. The TL200 can burn for up to 48 hours on a single load, making it an excellent choice for both convenience and efficiency.

The design of the TL200 is another aspect that sets it apart. It combines traditional aesthetics with modern functionality. The stove features a sleek, contemporary look, available in various finishes to complement any décor. The large viewing window allows users to enjoy the beauty of the flames while providing adequate heat to the room.

Safety features are also paramount in the TL200 design. The stove includes a built-in safety sensor that monitors temperature levels, ensuring that the unit does not overheat. An automatic shutoff feature provides peace of mind for homeowners, making it a safe option for families.

In conclusion, the Harman Stove Company TL200 pellet stove stands out for its eco-friendly burning technology, user-friendly controls, ample fuel capacity, attractive design, and safety features. For those seeking a reliable and efficient heating solution, the TL200 is an impressive option that combines performance with style.
Top Page Image Contents