Casablanca Fan Company 54005, 54007, 54006 operation manual Troubleshooting, Fan doesn’t work

Page 17

Troubleshooting

Fan doesn’t work

Make sure power switch is on.

Pull the pull chain to make sure it is on.

Push the motor reversing switch firmly left or right to ensure that it is engaged.

Check the circuit breaker to ensure the power is turned on.

Make sure the blades spin freely.

Turn off power from the circuit breaker, then loosen the canopy and check all the connections according to the wiring diagram on page 10.

Check the plug connection in the switch housing.

Excessive wobbling

Tighten all of the blade and blade iron screws until they are snug.

Turn the power off, support the fan carefully, and check that the hanger ball is properly seated.

Use the provided balancing kit and instructions to balance the fan.

www.CasablancaFanCo.com 1.888.227.2178

Noisy Operation

Tighten the blade and blade iron screws until they are snug.

Check to see if any of the blades are cracked. If so, replace all of the blades.

AUTHORIZED SERVICE CENTERS

For the most updated listing of Casablanca Authorized Service Centers, visit www.CasablancaFanCo.com or call toll free 1-888-227-2178.

17

M6004-01 • 08/13/12 • © Casablanca Fan Company

Image 17
Contents Table of Contents What to Expect with Your Installation Tools Needed Ceiling Standard Support Mounting StructureOutlet Box AngledFor angled ceilings, point Opening toward peak Ceiling Bracket InstallationMake sure all four 4 bumpers Are still attached Remove the shipping blocks from Ceiling Bracket Installation PreparationDownrod Tighten the setscrew Remove the pre-installed Hand tighten the downrod atSetscrew so that the downrod Leave at least 8 extendingFan Put the wires and downrod throughWiring Insert the two canopy screws Found Hardware bag CanopyYou kept after removing BladesFeed the wire plug through the center Switch HousingSocket Shade Socket Ring Socket Ring Tool Light KitHardware bag With bulbs of same wattage Insert three 3 switchHousing screws found Maintenance & Cleaning Fan doesn’t work Troubleshooting