Casablanca Fan Company 4726D owner manual Crossbar Mounting Bracket Installation

Page 4

FAN INSTALLATION GETTING STARTED

Installing a New Ceiling Fixture Outlet Box

If you do not have an existing fixture located where you wish to place your Casablanca fan, an approved ceiling fixture outlet box must be installed and wired.

WARNING!

To reduce the risk of fire, electrical shock, or personal injury, mount to outlet box marked “Acceptable Fan Support of 22.7 kg (50 lbs.) or less” using the mounting hardware provided with the outlet box.

Using Existing Ceiling Fixture Outlet Box

After turning the power OFF at its source (either the circuit breaker or fuse box), lower the old fixture and disconnect the wiring. Check the ceiling fixture outlet box to be sure it is marked “Approved for Ceiling Fan Mounting.” If it is not, a new box must be installed.

NOTE: The weight of this fan is 25 pounds.

CROSSBAR MOUNTING BRACKET INSTALLATION

CEILING HARDWARE (not to scale)

Wire Nut (4)

Crossbar Mounting Bracket

NOTE: After removing the old fixture, check the outlet box to insure that it is supported by a joist or beam across its upper surface. If not, a 2 x 4 stud must be installed.

Step 1a. Remove the knockout plug in the center of the outlet box or drill a ½" hole for the lag screw to pass through. Then drill a ¼" guide hole into the joist or beam to a depth of 3 inches.

Step 1b. Route the outlet box wires through the keyhole slot of the crossbar mounting bracket as shown. Attach the crossbar mounting bracket to the outlet box with the screws provided, making sure the outlet box wires are not pinched by the washer.

CAUTION:

To reduce the risk of personal injury, use only the mounting hardware provided with the approved outlet box to install the crossbar mounting bracket.

WARNING!

Support directly to building structure only.

Ceiling Fan

Approved

Wiring Box

Ceiling Wiring

Crossbar

 

Ridge Side

Mounting

Washer

Down

Bracket

 

 

 

 

Green

 

 

Ground Wire

 

Outlet Box

 

 

Mounting

 

 

Hardware

 

4

4743040 AT0907

 

 

Image 4
Contents Contents Read and Save These InstructionsSafe USE Introduction Beforeyou StartUnpacking Sloped Ceiling Installations Mounting Recommendations General GuidelinesInstalling a New Ceiling Fixture Outlet Box Crossbar Mounting Bracket InstallationUsing Existing Ceiling Fixture Outlet Box Prepare for fan installation as follows LAG Screw Installation OptionalFAN Preparation Canopy Hardware Canopy InstallationHanging the FAN Blade Installation Canopy Hatch InstallationCanopy Electrical Connections Remove Switch Housing CAP Screws BLADE/BLADE Holder InstallationRemove Shipping Blocks Connect Wires Install Switch HousingInstall Switch Housing CAP Screws Speed Operation Speed Optional Light Fixture InstallationPerformance and Energy Information Troubleshooting Tips Product Specifications Care RecommendationsAuthorized Service Centers STATE/CITY ZIP Service Center Name Phone Type Iowa STATE/CITY ZIP Service Center Name Phone Type MontanaKansas KentuckySTATE/CITY ZIP Service Center Name Phone Type Ohio STATE/CITY ZIP Service Center Name Phone Type TexasOklahoma Oregon