Casablanca Fan Company 4726D owner manual LAG Screw Installation Optional, FAN Preparation

Page 5

ESTRADA

LAG SCREW INSTALLATION (OPTIONAL)

NOTE: This step is required only under two conditions: If the fan weighs 36 lbs. or more (which does not pertain to this fan) or if the existing ceiling fixture outlet box needs to be modified for a ceiling fan application (for example, if the house is not new construction and you are replacing an existing light fixture). We recommend that the ceiling box be of sufficient capacity to support the weight of the fan and light fixture under any conditions. If in doubt whether you need to install the lag screw, consult a qualified electrician.

Step 2 (optional). With the large washer attached, pass the

Lag Screw

lag screw (Pack A) through the center hole of the crossbar

 

mounting bracket and screw into the guide hole. Tighten

 

until the outlet box is mounted firmly to the beam. This

 

box must be secured to the ceiling firmly.

 

 

PERMA•LOCK™ HARDWARE

Allen Set Screw

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

¼-20 x ¼"

 

 

3 mm

(Pre-installed)

 

 

Allen Wrench

FAN PREPARATION

CAUTION:

Before trimming wires or installing the downrod, pull the wires on the bottom of the fan to assure they are all the same length as shown.

Important safety information!

Before starting the installation of your ceiling fan, install the threaded

downrod into the motor coupling and lock the assembly.

Large Washer

Downrod & Ball

Assembly

Motor

Wires

Ground

Wire

Prepare for fan installation as follows:

Step 3a. Route the wires from the motor through the Perma•Lock™ downrod and ball assembly.

TIP: The downrod has a tapered thread that is designed to lock completely when correctly installed.

Step 3b. Using the provided allen wrench, loosen the set screw several turns to allow installation of the downrod. Thread the downrod into the motor coupling until it stops turning. This will take at least four and a half full turns.

Step 3c. Securely tighten the set screw with the provided allen wrench to ensure safe operation of your fan.

CAUTION:

Failure to fully lock in the downrod before securely tightening the set screw may cause the fan to separate from the downrod during normal operation!

Tapered

Allen Set Thread

Screw

Downrod

& Ball

Assembly

Motor

Coupling

4743040 AT0907

5

 

 

Image 5
Contents Read and Save These Instructions ContentsUnpacking Introduction Beforeyou StartSafe USE Mounting Recommendations General Guidelines Sloped Ceiling InstallationsUsing Existing Ceiling Fixture Outlet Box Crossbar Mounting Bracket InstallationInstalling a New Ceiling Fixture Outlet Box FAN Preparation LAG Screw Installation OptionalPrepare for fan installation as follows Hanging the FAN Canopy InstallationCanopy Hardware Canopy Electrical Connections Canopy Hatch InstallationBlade Installation Remove Shipping Blocks BLADE/BLADE Holder InstallationRemove Switch Housing CAP Screws Install Switch Housing CAP Screws Install Switch HousingConnect Wires Performance and Energy Information Speed Optional Light Fixture InstallationSpeed Operation Troubleshooting Tips Care Recommendations Product SpecificationsAuthorized Service Centers STATE/CITY ZIP Service Center Name Phone Type Montana STATE/CITY ZIP Service Center Name Phone Type IowaKansas KentuckySTATE/CITY ZIP Service Center Name Phone Type Texas STATE/CITY ZIP Service Center Name Phone Type OhioOklahoma Oregon