ESTRADA™
INSTALL SWITCH HOUSING
Step 13. Install 2 of the 3 switch housing screws onto the fan adapter plate, leaving 1/8" threads visible. Feed the wire connector from the fan through the center of the switch housing.
Align the 2 screws on the adapter plate with the keyhole slots of the switch housing. Raise the switch housing, pulling on the fan wire connector to assure no wires get pinched.
Turn the switch housing counter clockwise, engaging the 2 screws. Install the third screw and tighten all 3 screws.
Switch
Housing
Screw
CONNECT WIRES
Step 14. Plug the wire connector for the fan into the wire connector for the switch housing. Assure that the clip from the fan connector engages the notch on the switch housing connector.
Clip
2 Switch
Housing
Screws
Switch
Housing
Notch
INSTALL SWITCH HOUSING CAP SCREWS
Step 15. If you are installing a light fixture, please refer to the
If no light fixture is being installed, carefully push the wires and components back into the switch housing. Align the guiding pegs of the cap to the
4743040 AT0907 | 9 |
|
|