Indoor Coil Access Panel Relocation

	SEAL STRIP	SCREEN
	SEAL STRIP	RETAINER
		RETAINER
	HOOD TOP	HOOD SIDE
		HOOD SIDE
	SEAL STRIP
		SEAL STRIP
		SCREEN
		TRACKS
	HOOD
	SIDE	OUTDOOR AIR INLET SCREEN
		OUTDOOR AIR INLET SCREEN

OUTDOOR-AIR HOOD – UNASSEMBLED

HOOD TOP

HOOD

SIDE

TRACKS FOR AIR

CAULK

HERE

INDOOR

COIL

ACCESS

PANEL

SIDE

PANEL

TOP

SIDE

PANEL

INDOOR

COIL

ACCESS

PANEL

C06025

551J	INLET SCREEN
	j
	HOOD SIDES AND TOP ASSEMBLED

Fig. 10 - Indoor Coil Access Panel Relocation

C07504

Fig. 9 - Outdoor-Air Hood Details

Economizer Hood —

NOTE: If the power exhaust accessory is to be installed on the unit, the hood shipped with the unit will not be used and must be discarded. Save the aluminum filter for use in the power exhaust hood assembly.

1. The indoor coil access panel will be used as the top of

the hood. Remove the screws along the sides and bot-

LEFT
HOOD
SIDE	19 1/16”B
	(483mm)

TOP

PANEL

INDOOR COIL

ACCESS PANEL

SCREW

33 3/8”

(848mm)

	tom of the indoor coil access panel. See Fig. 10.
2.	Swing out indoor coil access panel and insert the
	hood sides under the panel (hood top). Use the screws
	provided to attach the hood sides to the hood top. Use
	screws provided to attach the hood sides to the unit.
	See Fig. 11.
3.	Remove the shipping tape holding the economizer ba-
	rometric relief damper in place.
4.	Insert the hood divider between the hood sides. See
	Fig. 11 and 12. Secure hood divider with 2 screws on
	each hood side. The hood divider is also used as the
	bottom filter rack for the aluminum filter.
5.	Open the filter clips which are located underneath the
	hood top. Insert the aluminum filter into the bottom
	filter rack (hood divider). Push the filter into position
	past the open filter clips. Close the filter clips to lock
	the filter into place. See Fig. 12.
6.	Caulk the ends of the joint between the unit top panel
	and the hood top.
7.	Replace the filter access panel.