Singer CLASS 99 instruction manual To Wind the Bobbin

Page 15

Class 99 & 99K

To Wind the Bobbin

Hold the hand wheel K, Fig. 16, with left hand and with right hand loosen stop motion screw L to disengage stitching mechanism.

Place empty bobbin on bobbin winder spindle, see Fig. 16. Turn bobbin until hole in right side engages pin in spindle. Press bobbin winder downward until latch M, Fig. 17, engages. In this position latch will hold bobbin in place.

Place spool of thread on spool pin 1.

Draw thread through guide 2 on arm of machine. Lead thread from front to rear through lower notch of guide 3.

Thread through O, Fig. 17, in left side of bobbin from inside. The end of the thread must be held by hand until it is broken off by the rotation of the bobbin.

Page 15

Table of Contents Previous Page Next Page

Image 15

Contents Class 99 & 99K Sewing Machines Sewing Suggestions Table of Contents Instructions for Operating the MachineLight Electrical InformationTo Insert New Bulb To Remove BulbIf the Machine is Electrically Operated To Operate the Hand Machine If the Machine is Hand OperatedBelt Shifter If the Machine is Treadle OperatedProtection Against Rust Damage To Oil the Machine and Stand Class 99 & 99K Needles and Thread To Set the Needle Upper Threading To Remove the Bobbin To Wind the Bobbin Class 99 & 99K To Replace the Bobbin Class 99 & 99KTo Prepare for Sewing To Start Sewing To Start SewingTo Remove the Work To Turn a CornerBasting To Sew Bias SeamsTo Reverse the Direction of Feed To Regulate Length of StitchThread Tension To Regulate Pressure on Presser FootTo Regulate Needle Thread Tension To Regulate Needle Thread TensionTo Regulate Bobbin Thread Tension Bobbin Thread Tension Table of Contents Previous Page NextTo Adjust the Needle Thread Tension To Adjust the Tension on the Thread Take-up SpringTo Adjust the Bobbin Thread Tension To Remove the Bobbin Case To Clean the Stitch Forming MechanismRaising the Bobbin Case Latch Removing the Bobbin Case To Replace Bobbin CaseTo Replace Slide Plate Sewing SuggestionsBreaking of Needles Might be Caused by Breaking of Needle Thread Might be Caused by Breaking of Bobbin Thread Might be Caused bySkipping of Stitches Might be Caused by Class 99 & 99K Foot Hemmer ApplicationsHemming Hemmed Seams Lace Applied over Hem Hemming with LaceInserting the Binding BinderAdjustment and Operation Binder Binding Curved Edges Inside CurvesOutside Curves Shirring Gathering FootRuffler Adjusting PointsGathering Forming and Attaching a Ruffle in One Operation Group Pleating PleatingSeam Guide Zipper Foot Skirt Zipper Corded Welting Corded Seams Fashion Aids ButtonholerBlind Stitcher Bias Gauge Joining Lace and Insertion EDGE-STITCHERTucking French SeamsQuilter Adjustable Hemmer To make hems from 3/16 to 15/16 inch wideWide Hemming Tucker Darning or Embroidering Needles Darning or Embroidering