Hoover U4361, U4359 manual Round handle

Page 7

Reinsert bolt through small holes of handle and secure with nut. Tighten nut with screwdriver. Proceed to Section C.

2) Round handle

A. Put handle together

Remove cardboard from the end of handle sections. Remove bolt and nut from upper handle sec- tion.

Slide the two handle sections to- gether, making sure that both cord storage hooks are on the same side of handle. Insert bolt through small holes and secure with nut. Tighten nut with screw- driver.

If the nut and bolt will not assem- ble as shown in the illustration, the holes in the handle are not lined up correctly.

B. Attach handle to the cleaner

Unscrew nut and remove bolt and plate from handle bail.

Take assembled handle and place so that the socket holes in the bottom of the handle are directly in line with the electrical prongs. Position the handle so that the ON-OFF switch is to the rear of the cleaner.

Push down until handle is secure- ly in place. Insert bolt into small hole in front of handle.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page Index Fill in and retain0IdL QB C UnpackingPage Put handle together How to assembleAttach handle to the cleaner Square handle with molded gripRound handle Attach outer bag to cleaner Check air freshener Attach throw away bag to cleanerHandle adjustment ON-OFF switchTo operate Pile height adjustment indicator Adjustment for carpet pile heightCarrying handle Special FeaturesAir freshener dispenser Quick cord release Cleaning ToolsEdge cleaning How to assemble hose and converterAttach converter Using cleaning toolsSelect proper cleaning tool Use correct handle position and carpet height adjustment To clean toolsAttach tool Bag MaintenanceBelt How to replace the headlightWhen to replace the belt HeadlightHow to replace the belt Agitator brushes When to replace brushesHow to replace the brushes If you have a problem Energy saving tips LubricationVcma
Top Page Image Contents