Hoover U4361, U4359 manual How to replace the brushes

Page 21

How to replace the brushes

(Brushes - HOOVER part No. 48445001)

Disconnect cleaner from electrical outlet.

1.To replace worn brushes, remove bottom plate, belt and agitator, fol- lowing directions given on preceding pages.

2.Turn end plates of agitator in opposite directions until one end plate comes off.

4.Remove opposite end plate and shaft by pulling straight out. Pry out remaining end section.

6.To reassemble, reverse proce- dure. Replace the last end sec- tion removed, then end plate and shaft. Replace remaining end sec- tion and end plate. Be sure end sections are assembled with loca- tor lined up with slot in agitator.

3.Then pry out end section as shown.

5.Remove brushes by pulling them from agitator. Use pliers if neces- sary. Slide new brushes into chan- nels. Push them in as far as possi- ble.

I END SECTION

7.Should you accidentally dis- place the bearing during disas- sembly, reassemble as shown.

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Page Index Fill in and retain0IdL QB C UnpackingPage Attach handle to the cleaner How to assembleSquare handle with molded grip Put handle togetherRound handle Attach outer bag to cleaner Check air freshener Attach throw away bag to cleanerON-OFF switch Handle adjustmentTo operate Pile height adjustment indicator Adjustment for carpet pile heightSpecial Features Carrying handleAir freshener dispenser Edge cleaning Cleaning ToolsHow to assemble hose and converter Quick cord releaseAttach converter Using cleaning toolsSelect proper cleaning tool To clean tools Use correct handle position and carpet height adjustmentAttach tool Bag MaintenanceWhen to replace the belt How to replace the headlightHeadlight BeltHow to replace the belt Agitator brushes When to replace brushesHow to replace the brushes If you have a problem Energy saving tips LubricationVcma
Top Page Image Contents