Hoover S3083-030 manual HOW to Store, Maintenance, To Clean Hard to Reach Areas, To Clean Stairs

Page 10

TO CLEAN HARD TO REACH AREAS

Use the curved wand with the extension wands. The tools attached to the curved wand will enable you to clean many hard to reach areas; especially crown moldings, tops of drapery rods, shelves, and picture frames, etc.

TO CLEAN STAIRS

Clean stairs by placing the cleaner on its side as pictured in the illustration. Clean stairs from bot- tom to top.

HOW TO STORE

CORD WRAP When the cleaner is not in use, wrap the cord around the cord storage hooks located on the cover of the cleaner.

Store the power nozzle with the handle in the upright or storage position. NOTE: When storing

the nozzle, make certain the Surface Selector

Lever is in the “Carpet” position. The hose, extension wands and power nozzle can be stored separately from the cleaner if desired.

MAINTENANCE

The following sections are concerned with proper maintenance of the

 

cleaner. Familiarize yourself with these home maintenance tasks and keep

 

this owner’s manual in a convenient place where you can refer to it when

 

needed. Proper use and care of your cleaner will insure continued effec-

 

tiveness.

I

 

REPLACING THE THROW AWAY BAG

DISCONNECT CORD FROM ELECTRICAL OUTLET BEFORE CHANGING PARTS

9

l

,

/

. . .

Image 10
Contents S3083-030 Index Importantsafeguards Dusting Brush Cord Storage Hooks WALL/FLOOR BrushCover Latch Carrying Handle Crevice Tool Furniture Nozzle HOW to Connect the ‘POWERMATIC’ Nozzle To Connect and Remove HoseHOW to USE Carpet and RUG CleaningFor Hard Surface Floor Cleaning Cleaning Tools HOW to USE the ‘CELEBRITY II’ Cleaner with Cleaning ToolsTo Connect and Remove Tools To Clean Hard to Reach Areas HOW to StoreMaintenance To Clean StairsHow To Replace When To ReplaceThrow Away Bags HOW to Replace the Belt HOW to Clean Secondary FilterWhen to Replace the Belt On Power Nozzle BeltPage Trated. Fig Check to be sure belt is not twistedNozzle Hose Agitator BrushesLocator Bottom Plate BrushEND Section WAS Bearin HOW to Replace Bottom Plate Brush Suction Problem Possible Cause Possible Solution CleanerWON’T RUN LOWEnergy Saving Tips LubricationLubricant to either motor bearing For Best Performance To Avoid Accidents5 7 8 S3083-030 Litho USA 56513-058