Hoover S3083-030 manual

Page 13

To provide space for grasping the agitator, remove end of hose from holder, Fig. 3.

Then grip agitator and pull out. Fig. 4. Remove old belt.

Place one end of the new belt around agitator pulley with smooth side of belt against the pulley. Fig. 5.

Line up metal projection on end of agitator (opposite the belt) with groove on inside wall of nozzle. Fig. 6. Then slide agitator into place.

Replace end of hose in holder. Fig. 7.

Image 13

Contents S3083-030 Index Importantsafeguards Dusting Brush Cord Storage Hooks WALL/FLOOR BrushCover Latch Carrying Handle Crevice Tool Furniture Nozzle To Connect and Remove Hose HOW to Connect the ‘POWERMATIC’ NozzleCarpet and RUG Cleaning HOW to USEFor Hard Surface Floor Cleaning Cleaning Tools HOW to USE the ‘CELEBRITY II’ Cleaner with Cleaning ToolsTo Connect and Remove Tools Maintenance HOW to StoreTo Clean Hard to Reach Areas To Clean StairsHow To Replace When To ReplaceThrow Away Bags When to Replace the Belt On Power Nozzle HOW to Clean Secondary FilterHOW to Replace the Belt BeltPage Check to be sure belt is not twisted Trated. FigAgitator Brushes Nozzle HoseLocator Bottom Plate BrushEND Section WAS Bearin HOW to Replace Bottom Plate Brush WON’T RUN Problem Possible Cause Possible Solution CleanerSuction LOWEnergy Saving Tips LubricationLubricant to either motor bearing For Best Performance To Avoid Accidents5 7 8 S3083-030 Litho USA 56513-058