Place a screwdriver under the belt as illus-
trated. Fig. 8.
8
Bracing the end of the screwdriver against the end of the motor shaft, slide belt over end of shaft. Fig. 9. Remove screwdriver.
Check to be sure belt is not twisted.
9
Rotate the agitator by hand to properly align the belt on the motor shaft. Agitator should rotate freely. Fig. 10.
IO
Replace agitator dirt seal. Place beveled end toward front. Fig. 11.
11
Replace bottom plate by fitting the plate over the lip at the front of the nozzle hous- ing. Line up the slots over the wheels and position holes in bottom plate over screw
mountings. Fig. 12. Replace screws.
12
13