Hoover S3083-030 manual Bottom Plate Brush, Locator, END Section WAS Bearin

Page 16

LOCATOR

Remove brushes by pulling them from agitator with pliers. Slide new brushes into the channels - small ends first - pushing them in as far as possible. (Fig. 4).

Replace end plate and shaft, lining up locator on end section with slot in agitator. Replace other end section and end plate and tighten. (Fig. 5).

END SECTION WAS

BEARIN

5

Should you accidentally displace the bearing during disassembly, re- assemble as shown.

BOTTOM PLATE BRUSH

Periodically, check the Bottom Plate Brush to see whether or not bristles have become worn. Put the Surface Selector Lever in the “Bare Floor” position. Place a straight edge across the brush opening to check the length of the bristles. The bristles should extend beyond the bottom plate, l/16” or more.

15

Image 16

Contents S3083-030 Index Importantsafeguards Dusting Brush Cord Storage Hooks WALL/FLOOR BrushCover Latch Carrying Handle Crevice Tool Furniture Nozzle HOW to Connect the ‘POWERMATIC’ Nozzle To Connect and Remove HoseHOW to USE Carpet and RUG CleaningFor Hard Surface Floor Cleaning Cleaning Tools HOW to USE the ‘CELEBRITY II’ Cleaner with Cleaning ToolsTo Connect and Remove Tools HOW to Store MaintenanceTo Clean Hard to Reach Areas To Clean StairsHow To Replace When To ReplaceThrow Away Bags HOW to Clean Secondary Filter When to Replace the Belt On Power NozzleHOW to Replace the Belt BeltPage Trated. Fig Check to be sure belt is not twistedNozzle Hose Agitator BrushesLocator Bottom Plate BrushEND Section WAS Bearin HOW to Replace Bottom Plate Brush Problem Possible Cause Possible Solution Cleaner WON’T RUNSuction LOWEnergy Saving Tips LubricationLubricant to either motor bearing For Best Performance To Avoid Accidents5 7 8 S3083-030 Litho USA 56513-058