Hoover S3083-030 manual Problem Possible Cause Possible Solution Cleaner, Won’T Run, Suction, Low

Page 18

USER CHECK LIST

This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem develops, it usually can be remedied quite easily when the cause is identified. Accordingly, this check list is provided for your convenience.

PROBLEM

POSSIBLE CAUSE

POSSIBLE SOLUTION

 

 

 

A. CLEANER

1. Not firmly plugged in.

1. Plug unit in firmly.

WON’T RUN

2. No voltage in wall plug.

2. Check fuse or breaker.

 

3. Blown fuse/tripped breaker.

3. Replace fuse/reset breaker.

 

 

 

B. CLEANER

1. Bag full.

1. Change throw-away bag.

SUCTION

2. Hose(s) or cleaning tool

2. Remove foreign object.

LOW

clogged.

 

 

3. Secondary filter clogged.

3. Clean filter.

 

4. Bag not opening.

4. Open bag by pulling pleats.

 

5. Suction regulator control

5. Check to be sure suction

 

improperly set.

regulator is set properly.

 

6. Hose not connected to

6. Insure hose connected

 

cleaner properly.

properly.

 

 

 

C. AGITATOR

1. Hose power cord not firmly

1. Plug firmly into receptacle

WON’T RUN

plugged in.

on Cleaner base and under-

 

 

neath handle.

 

2. Broken or worn belt.

2. Replace belt.

 

 

 

Il. NOZZLE

1. Low cleaner suction.

1. See Item B.

WON’T PICK

2. Nozzle clogged.

2. Remove foreign object.

UP

3. Agitator not running.

3. See Item C.

 

4. Agitator brushes worn.

4. Replace brushes.

 

 

 

If the problem persists, check the Yellow Pages of your telephone book under “Vacuum Cleaners - Household” for your nearest Hoover Factory Service Center or Authorized Warranty Service Dealer where approved service and genuine HOOVER replacement parts may be obtained. The warranty provided with this product has a listing of the Hoover Factory Service Centers. If you are unable to obtain the information you need from the Yellow Pages, contact a Hoover Factory Service Center to find your nearest Authorized Warranty Service Dealer. For service under warranty, follow the instructions in the Warranty provided with this product.

Always identify your cleaner by model number when requesting information or ordering replacement parts. (The model number appears on the bottom of the cleaner.)

If further assistance is needed, contact the Hoover Company Consumer Affairs Department, North Canton, Ohio 44720,216-499-9200.

17

Page 17 Page 19
Image 18
Page 17 Page 19
Contents S3083-030 Index Importantsafeguards Dusting Brush WALL/FLOOR Brush Cord Storage HooksCover Latch Carrying Handle Crevice Tool Furniture Nozzle HOW to Connect the ‘POWERMATIC’ Nozzle To Connect and Remove HoseHOW to USE Carpet and RUG CleaningFor Hard Surface Floor Cleaning HOW to USE the ‘CELEBRITY II’ Cleaner with Cleaning Tools Cleaning ToolsTo Connect and Remove Tools To Clean Hard to Reach Areas HOW to StoreMaintenance To Clean StairsWhen To Replace How To ReplaceThrow Away Bags HOW to Replace the Belt HOW to Clean Secondary FilterWhen to Replace the Belt On Power Nozzle BeltPage Trated. Fig Check to be sure belt is not twistedNozzle Hose Agitator BrushesBottom Plate Brush LocatorEND Section WAS Bearin HOW to Replace Bottom Plate Brush Suction Problem Possible Cause Possible Solution CleanerWON’T RUN LOWLubrication Energy Saving TipsLubricant to either motor bearing To Avoid Accidents For Best Performance5 7 8 S3083-030 Litho USA 56513-058
Top Page Image Contents