Belt
! CAUTION !
To reduce the risk of injury from moving parts, unplug vacuum before servicing.
The belt is located under the bottom plate of the vacuum and should be checked from time to time to be sure it is in good condition.
When To Replace
Replace belt if it is stretched, cut or broken. To check the Stretch belt, refer to Fig. 4.22 - 4.24.
How To Replace
4.22Turn vacuum over so bottom side is facing up. Rotate red upper latch (A) counter clockwise.
4.23Slide red lower latch (B) to the unlock position.
4.24Lift off bottom plate.
4.25Remove used belt from brushroll (C) then from motor shaft (metal rod) (D) and discard.
Flat Belt: What to Buy
Use only genuine HOOVER® belts with your vacuum. When purchasing a new belt, ask for Flat Belt - HOOVER® part No. 562289001.
4.26With lettering on outside of belt, slide new belt over motor shaft (metal rod) (E).
Push other end of belt through belt guide (F) and over metal pulley, then slip around area of brushroll without bristles (G).
With belt in place, pull and slide brushroll into nozzle making sure that the brushroll end caps are in the correct orientation.
IMPORTANT
Rotate brushroll manually to make sure belt is not twisted.
4.27Reposition bottom plate, aligning tabs along front edge of nozzle guard with slots in nozzle. Rotate back into position. Slide red lower latch to Lock position, and rotate red upper latch clockwise.
4.22 | A |
|
4.24 |
4.26 |
|
| E |
F | G |
4.23 |
B |
4.25 | D | C |
|
4.27 |
12