Maintenance and care
Cleaning the dirt container
Additional steps can be taken to clean the dirt container as necessary.
1.Ensure the dirt container has been emptied.
2.Remove the lower portion by pressing the front and back latches on the upper portion as shown.
3.Clean the screen with a cloth or soft brush to remove dust or debris.
4.If desired, the lower dirt container may be washed in warm water. Make sure it is completely dry before reassembling.
5.To reassemble, hold the carry handle and place the upper portion into the lower portion, lining up the front and back latches. Push down until both latches click into place. Make sure the dirt container is securely assembled before replacing it on machine.
Cleaning the foam filter
The foam filter should be checked monthly and washed as needed to maintain performance. More or less frequent cleaning may be required based on individual vacuuming habits and types of debris picked up .
1.The foam filter is located in the tray labeled "Filter" underneath the dirt container. Pull the tray out to access the filter.
2.Remove foam filter from tray and hold under running water to wash. Mild detergent may also be used if desired. Wring excess water from filter. Air dry thoroughly before replacing.
WARNING:
To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug from electri- cal outlet before perform- ing maintenance or troubleshooting checks.
2
3
5
WARNING:
Do not operate the cleaner with a damp or wet filter or without all the filters in place.
1
10 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1