Operation
Height adjustment
There are seven height settings available for various floor surfaces. Turn the dial on the foot of the cleaner to the desired setting.
Lowest setting – For bare floors.
Medium settings – For short and medium pile carpets.
High setting – For plush carpet.
Note: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.
If the dial is difficult to turn, tilt the cleaner
back slightly to take the weight off the foot while turning.
Fingertip brush switch
The rotating brush is turned on or off using the switch at the side of the top of the handle. The brush will start rotating when the unit is reclined. The brush should be on for most carpeted floors. You may want to turn the brush off for bare floor cleaning or other delicate surfaces.
To turn the brush ON, press | button once. |
To turn the brush OFF, press | button again. |
Brush auto shut-off feature
When your cleaner is in the upright position, the brush will not rotate. The brush will rotate only when the cleaner is in the reclined position and the brush switch is on.
ATTENTION:
Some Berber carpets have a tendency to fuzz with wear. Repeated strokes in the same area may aggravate this condition. Consider setting your cleaner on a higher than normal setting for this type of carpet.
w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1 | 7 |