Bissell 50C9 warranty Tool required Phillips screwdriver, Attach hose by lining up the tabs on

Page 5

Assembly

Tool required: Phillips screwdriver

1.Slide upper handle onto lower handle. Insert one screw into hole marked with an arrow and tighten until snug.

2.Attach hose by lining up the tabs on the

collar with the corresponding notches on

1

the back of the vacuum as shown. Turn clockwise to lock the hose into place.

3.Wrap the hose by routing it down and into the lower hose clip then up and over the top of the handle. Insert the hose wand fully into the hose base.

Note: It is important that the hose is fully inserted into the base for the suction air to be directed properly to the foot during floor vacuuming.

4.Store TurboBrush on the front of the handle 3 by aligning the slot at the bottom with the

tab and snapping into place.

5.Place crevice tool inside telescoping extension wand. Store tools on vacuum as shown.

CAUTION:

Do not plug in your vacuum cleaner until you are familiar with all instructions and operating procedures.

2

4

5

w w w . b i s s e l l . c o m

8 0 0 . 2 3 7 . 7 6 9 1

5

Image 5

Contents E R ’ S G U I D E C U U MThank you for buying a Bissell Heavy Duty Vacuum Important Safety Instructions Hose Collar Brush Window Attach hose by lining up the tabs on Tool required Phillips screwdriverReleasing the power cord Transporting your cleanerFingertip power switch Power button is located at the top of the vacuum handleBrush auto shut-off feature Height adjustmentFingertip brush switch TurboBrush Using the toolsUpholstery tool Crevice toolChoose an emptying method Emptying the dirt containerCleaning the foam filter Cleaning the dirt containerMaintenance and care Check to see if dirt container is full. Empty if needed Clearing clogsThermal motor protection Belt maintenance Brush resetBrush maintenance Ing straight out of the socket. Install the new TurboBrush maintenanceChanging the light bulb Ends into slots on sides as shownBrush not rotating Vacuum cleaner won’t turn onVacuum cleaner won’t pick up or low suction Authorized service representative Vacuum cleaner is difficult to pushVisible dust escaping from cleaner Bissell Consumer Services 131415 Part NameIf your Bissell product should require service Limited Five Year WarrantyWebsite or E-mail Or Call