OWNER’S MANUAL
INSTALLATION
Continued
Test Pressures Equal To or Less Than 1/2 PSIG
1.Close manual shutoff valve (see Fig- ure 7).
2.Pressurize supply piping system by either using compressed air or opening main gas valve located on or near gas meter.
3.Check all joints from gas meter to manual shutoff valve (see Figure 7). Apply mix- ture of liquid soap and water to gas joints. Bubbles forming show a leak.
4.Correct all leaks at once.
Manual Shutoff Valve
Gas Meter
3.Place burner manifold in pan with threaded opening facing open
4.Thread the gas control valve onto the burner inlet fitting (see Figure 10). Use thread sealant on the male threads of the burner inlet fitting. Hold the burner inlet fitting with a wrench to prevent overtightening the connection to the burner. Make sure the control knob is facing the front (see Figure 10).
5.Using burner clamp, screw, and nut pro- vided, assemble clamp to pan (“U” style burners only). This will hold the burner manifold in place (see Figure 9).
6.Attach the pilot gas line to the pilot outlet of the gas control valve and tighten. Connect the thermocouple to the terminal block on the gas control valve. See Figure 11. Do not over- tighten. If using propane/LP gas, see Changing Pilot Orifice, page 11.
Nut
7.Install the inlet fitting into the inlet opening of the gas control valve (see Figure 12). Use thread sealant on the male pipe threads.
8.Place the burner pan assembly in the center of the fireplace floor. Make sure the front of pan faces forward.
9.Thread the gas supply adaptor to the fireplace gas supply pipe. Adjust to most convenient position.
10.Install the gas connector tube to the gas supply adaptor. Carefully shape tube and attach to gas inlet fitting (see Figure 12). Be careful not to cause kinks in tube.
11.Test for leaks following instructions under Testing Burner for Leaks, page 11.
12.Retighten and adjust the location of the gas control as necessary. The gas con- trol should be level, with the control knob to the front.
Thermocouple
and Line
Figure 7 - Checking Gas Joints
HEARTH KIT ASSEMBLY AND INSTALLATION
Burner
Clamp
Burner Manifold
Pilot and Line
Pressure
Gas
Control
Valve
Kit Assembly
Note: The following instructions apply to both standard single bar burners, as well as dual flame “U” style burners. Be sure all pipe threaded connections are tight, and have thread compound to prevent leaks.
1. Determine which side the gas line will |
Burner
Pan
Screw
Tap - Out |
| O |
| OLI | |
|
| F |
| O | F |
| N |
|
|
| T P |
(Manifold) |
|
|
Pressure Tap - In (Inlet)
Figure 11 - Gas Control Valve with Ther- mocouple and Pilot
Gas
Connector
be coming into the fireplace. |
2. Using a hammer and screw driver, re- |
move |
the pan that corresponds to the gas line |
(see Figure 8). |
Burner Pan
Assembly (Facing
Front of Fireplace)
Figure 8 - Knock-Out Plug Locations
Figure 9 - Installing Burner
Gas
Control
Valve
Burner Pan
Assembly
Burner Inlet Fitting
(containing orifice)
Control Knob
Figure 10 - Installing Gas Control Valve
Tube
O | |
| F |
NO | F |
T O | P |
Gas Control | Inlet | Gas Inlet | |
Opening | |||
Valve | |||
| Fitting | ||
|
|
Figure 12 - Installing Inlet Fitting and Gas Connector Tube
Continued
901272 | 9 |