4. INSTALLATION
Fabricate these cables as below to connect to the receiver unit.
Vinyl sheath
25 mm
5 mm
100 mm
Soldering | Vinyl wire |
Scrape the paint off the cable
where the cable contacts the cable clamp.
TTYCS-1Q (For Navigator or INS)
Shield
5 mm
| 25 mm |
|
| 100 mm | |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Soldering | Vinyl wire | ||
Vinyl sheath |
|
| ||
Scrape the paint off the cable |
|
| ||
where the cable contacts the cable clamp. |
|
| ||
DPYC-2.5 (For ship’s battery)
25 mm
5 mm
100 mm
Vinyl sheath
Scrape the paint off the cable
where the cable contacts the cable clamp.
How to use J402 and 403 connector
1.Insert the terminal opener (attached in the receiver unit) into the connector.
2.Insert a wire in terminal while pressing and holding the terminal opener.
3.Release the terminal opener. Pull wire to confirm that it is connected firmly.
Terminal opener
Wire