Genie POWERLIFT 900 REMOTES / New Intellicode 2 Openers, Required Programming, HOLD 2 seconds

3 Required Programming

REMOTES / New Intellicode 2 Openers

NOTE: The following instructions are for the remote control transmitters (“Remotes”) provided with this opener. This Remote is preset for use with the Intellicode 2 Access Security System. Refer to page 14 for additional information on Intellicode 1 and 2 Remotes and how to switch from Intellicode 2 to Intellicode 1. See page 14

for programming instructions using Intellicode 1 Remotes.

NOTE: You have 30 seconds to execute each step. If you see two flashing red LEDs on the Powerhead, you have run out of time and must go back to the beginning of the step and start over. You can restart as many times as necessary to complete each step.

NOTE: Each button on each Remote must be programmed separately, following these steps.

14 Press and hold the Program Set button (the round LED turns blue).

PROGRAM

– +

HOLD 2 seconds

15 Release the Program Set button (the long LED begins flashing purple).

PROGRAM

– +

16 Remove protective film for battery from remote.

PUL

17 Press and release the button you have choosen on the Remote (long LED comes on purple).

PROGRAM
SET	–	+

	NOTE: Do NOT hold Remote too close to the Powerhead when
	programming Remote buttons.
10	(continued next page)
G999-393 Manual-ScrewBeltChain-EN indd 10	7/13/12 10 17 AM