Genie M-4500, M-4700 owner manual Transmitter Mounting, Multiple Transmitters, Code Change

10. TRANSMITTERS

INSTALLING THE BATTERY (Fig. 47.):

■Remove battery compartment cover (back of transmitter) by using small screwdriver.

■Insert the provided 12V battery (type 23A) as shown.

■Replace battery compartment cover.

NOTE: Replace batteries with same type only.

TRANSMITTER MOUNTING:

The transmitters can be conveniently mounted inside your car using the mounting plate, or visor clip.

A. Mounting Plate (Fig. 48)

■Secure the mounting plate to area of preference using velcro (not provided) or other means.

■Snap the transmitter into the mounting plate, which will hold it firmly in place.

B. Visor Clip (Fig. 48)

The visor clip permits easy mounting of transmitter to a visor.

■Attach visor clip to mounting plate.

■Snap transmitter into mounting plate.

■Affix complete assembly to visor.

MULTIPLE TRANSMITTERS:

Each transmitter comes factory programmed with random codes. 1-channel transmitters have one random code, and

2-channel transmitters have 2 different random codes, one per button. Transmitters that are purchased separately as accessories have random codes that must be changed in order to match the code of the “active” transmitter you are already using. Below are instructions for transferring an active code.

■Remove battery compartment covers of both transmitters, the one with the active code and the new transmitter that needs to receive the active code. See Fig. 47.

■Connect the programming cable to both transmitters. Line up either end of stripped cable so 3 wires align with 3-hole terminal, then firmly insert cable. See Fig. 49.

■Press and hold button on transmitter with the active code ((L) in Fig. 49). Midi transmitters have indicator lights that will blink to show that code transfer is ready.

■While keeping the transmitter (L) button pressed, press and hold the button on the new transmitter (R) that you want to transfer the active code to.

■Code transfer will occur in approximately 2 seconds. The indicator light will illuminate continuously to show that transfer is complete.

■All buttons can be released. Cable can be removed and the covers replaced.

■Both transmitters can now be used to operate the same door.

NOTE: For multi-button transmitters, be sure to carry out this procedure for all the buttons you desire to use.

CODE CHANGE:

The transmitter factory preset code can be changed as follows:

■Remove battery cover from compartment.

■Connect the programming 3-prong cable to programming terminal in transmitter. (Fig. 50).

■Cross any two wires of programming cable, one of them must be the center wire.

■Press and hold button on the transmitter.

■Code will change in approximately 2 seconds.

■Release button after the light illuminates continuously, then- remove the cable and replace the cover.

Fig. 47	Battery
	Compartment
	Cover
	12 V
	(type 23A)
	Battery
	Programming
	Cable
	3-Hole
	Terminal
Fig. 48	Midi 2-Channel
	Fully Assembled

		Transmitter
		Mounting Plate
		Visor Clip
Fig. 49	L	R

Transmitter	New
with Active	Transmitter
Code

L	R	Light	Light	L	R	Light
Light
Blinks		Off	Blinks			Illunimates
						Continuously

Press First	Press Second	Keep Pressed	Release when
and hold	and hold		Light Illunimates
			Continuously

FCC Certified: This device complies with Part 15 of the FCC rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Fig. 50

NOTE: For multi-button transmitters, be sure to carry out this procedure for all the buttons you desire to use.

22