ATTENTION
If your garage door opener has a Serial Number sticker which looks like this, in which the first two numbers are 10 or higher, your opener is equipped with INTELLICODE®2.
MODEL AC SR3 | THE GENIE COMPANY |
FCC ID: B8Q AC SR3 | Residential Door Operator |
IC: 2133A CSD1D | 120V 60HZ 5A |
S/N 10XXXX XXXXXXX |
|
FOR H P CA 1 800 35GEN E OR WWW GEN ECOMPANY COM
If you have another garage door opener that does NOT have a Serial Number like this, then you will be using the INTELLICODE® 1 setting on your remote to operate that opener.
INTELLICODE® FEATURES
Other models of Genie® garage door openers, remotes, and wireless keypads use IntelliCode® 1 signals to communicate. Remote(s) provided with this unit will transmit either IntelliCode® 1 or IntelliCode® 2 signals.
Remote(s) contained in this package are preset to IntelliCode® 2 and can be configured to communicate with previously installed IntelliCode® 1 openers. This dual IntelliCode® option allows one IntelliCode® 2 remote to operate different models of The Genie Company garage door openers.
This new Genie® garage door opener will ONLY accept signals from a remote sending IntelliCode® 2 signals (see page 9) or a Genie® brand IntelliCode® 1 remote that has been programmed to the opener using a new IntelliCode® 2 remote (see page 10).
NOTE: Other remotes not enabled with Genie® IntelliCode® 2 will not operate this opener.
| Use this |
If you have ... | IntelliCode® |
| programming |
One or more IntelliCode® 2 | Use IntelliCode® |
openers with a maximum 3 | 2 |
different openers |
|
Mixture of openers | Use IntelliCode® |
manufactured between 1997 | 2 and/or 1 |
and 2010 (IntelliCode® 1) and |
|
new IntelliCode® 2 openers |
|
One or more openers | Use IntelliCode® |
manufactured between 1997 | 1 |
and 2010 (IntelliCode® 1) |
|
NOTE: A maximum of 3 different openers can be programmed to a 3 button remote.
Three button
remote
Green LED
Red LED
Programming remote to previously installed IntelliCode® 1 Genie® garage door openers
Remotes provided with this unit can operate other (IntelliCode® 1) models of Genie® garage door openers. The default IntelliCode® 2 setting must be changed to IntelliCode® 1. (Follow these same steps to change IntelliCode® 1 back to IntelliCode® 2.)
The LED color displayed on the remote indicates the IntelliCode® mode.
Red = IntelliCode® 1 / Green = IntelliCode® 2
1.Select a button on the remote that has NOT been
programmed to the
new powerhead.
2. Press and hold that button for 10 seconds.
Both Red and Green
LEDs come ON and stay 10 SECS ON.
3. Press the same button twice to toggle IntelliCode® selection from IntelliCode® 2 to IntelliCode® 1.
4. Press the same button again to confirm toggle. The IntelliCode® selection for this button is set to IntelliCode® 1.
5.Take the remote to the older Genie® garage door opener and follow that opener's instructions to program a new remote.
Repeat for other Genie® garage remote(s) as necessary.
16 | ©2011 The Genie Company | 3/2011 |