Harman-Kardon HS 250 owner manual Optional Audio Connections, Speaker Placement

Page 15

Installation and Connections

Connecting VCR and Sat Decoder (method 5 and 6)

Diagrams 5 and 6 show possible connection methods for common system configurations. These are intended as guidelines only. Due to differences in equipment specifications, the method of connection of your equipment may be different to that shown. Please consult the Owner’s Manual of your equipment for further guidance.

AUDIO OUT

AUDIO OUT

 

TV SET

VCR

SATELLITE DECODER

Connecting Set-top Box or Digital Satellite Receiver (method 7) - using coaxial digital cable

To listen to the digital multichannel signal or downmix from Set-top boxes or digital satellite receivers, connect the Coaxial Digital Out of your device to the Coaxial Digital In ￿ on the HS controller.

Aux Output for Recording

To record the sound of the HS system with your VCR or any audio recording device (tape deck, MD, CDR and some others.) the Audio Out jacks

￿should be connected to the analog Record In jacks of the appropriate device. They can also be connected to any audio input on your TV to lis- ten to the sound of your HS controller through the speakers of your TV only, when the amp in your subwoofer is turned off and the volume of the HS controller has been turned down com- pletely. If the speakers of your HS system are active, the volume on your TV should be turned down.

Digital In- and Outputs

Connect the digital output of any digital sources such as an optional CD or DVD changer or play- er, advanced video game, a digital satellite receiver, HDTV tuner or digital cable set-top box or the output of a compatible computer sound card to the Optical and Coaxial Digital Inputs ￿￿.

Connect the Coaxial Digital Output ￿ on the rear panel of the HS to the matching digital input connections on a CD-R or MiniDisc recorder.

Notes when connecting the optical digital audio cable (optional)

Gently push the cable plug through the built- in shutter that covers the optical digital audio output and connect the cable firmly so that the configurations of both the cable and the connector match.

Left Front

Right Front

Speaker

Speaker

A)Front Channel Speaker Installation with Direct-View TV Sets or Rear-Screen Projectors.

 

TV or Projection Screen

Left Front

Right Front

Speaker

Speaker

B)The distance between the left and right

speakers should be equal to the distance from the seating position to the viewing screen.

ENGLISH

DIGITAL OUT

Optional Audio Connections

Aux Input for External Source

You may connect a line-level stereo analog audio source such as a Sat receiver, tape deck, phono preamp of a record player, etc. to the controller's rear panel AUDIO IN Input ￿ sock- ets to enjoy the benefits of your HS system with other source components.

VCR Connection-Audio (Cables Not Included). To listen to the sound from your stereo VCR through the speakers of this system, connect the Left/Right audio output jacks of your stereo VCR to the Left/Right audio input jacks AUDIO IN ￿ of this system.

Speaker Placement

The placement of speakers in a 2.1 audio/home theater system can have a noticeable impact on the quality of sound reproduced.

Position the left-front and right-front speakers so that they are as far away from one another as from the preferred listening position.

If possible, adjust all front loudspeakers so that they are aimed at ear height when you are seated in the listening position.

This will give you the best result for enjoying Dolby Virtual Surround by using only front left and right speakers.

Using these guidelines, you’ll find that it takes some experimentation to find the correct loca- tion for the front speakers in your particular installation. Don’t be afraid to move things around until the system sounds correct. Optimize your speakers so that audio transitions across the front of the room sound smooth.

Subwoofers produce largely nondirectional sound, so they may be placed almost anywhere in a room. Actual placement should be based on room size. One method of finding the optimal location for a subwoofer is to begin by placing it in the front of the room, about 15cm from a wall, or near the front corner of the room. Another method is to temporarily place the sub- woofer in the spot where you will normally sit, and then walk around the room until you find a spot where the subwoofer sounds best. Place the subwoofer in that spot.

INSTALLATION AND CONNECTIONS 15

Image 15
Contents HS 250 Home Cinema System Declaration of Conformity Table of ContentsIntroduction Important Safety Information Introduction / Safety InformationDivX TerminologyTerminology This information is compressedFeatures Eject Press this button to release a disc from the loader Power On/Off Standby Headphone Jack Eject Volume ControlFront Panel Controls  Main Information Display USB On-The-Go InputLights when the disc is paused Disc Type IndicatorsFVideo Format Indicators Lights when a disc is playing in the normal modeFM Antenna Connect to the supplied FM antenna Rear Panel ConnectionsRear Panel Connections Clear Button Remote ControlB Button Press to select section A-B and to play repeatedly Mute Button Mutes the soundBasic Information About This ManualRegional Coding Video Equipment Connections Installation and ConnectionsConnecting the TV and optional components Audio Equipment ConnectionsOptional Audio Connections Speaker PlacementBasic Play Connecting the AC PowerDisc Playback Features First Turn OnPlaying a DivX Movie Disc Surround ModeSlow Motion Playback with DVD only About DivX Movie FilesSystem Settings System SetupSystem Defaults Set Up MenuOutput level adjustment Audio SettingsAudio Adjustment Feel free to experiment with the settings at any timeDivX Video On Demand Video SettingsVideo Adjustment Press the Video Output Button on the remote controlTV Picture Adjustment with Test Screen Test ScreenTest Screen Player/Radio Menu Auto Preset function Surround Mode for TunerRDS Station ID Surround Mode Chart Dolby Digital signals will be down-mixed toTV Menu, AUX Menu, Digital in Menu Using Random Activates Random Playback when possi- bleUSB Menu Macro Programming Learning Codes from a RemoteLearning Codes from a Remote Erasing Learned CodesMacro has been erased Erasing Macro CommandsWhen the Program Indicator DVD Language CodesTroubleshooting Angles cannot be changed when you play a DVD Audio language cannot be changed when you play a DVDSubtitle language cannot be changed when you play a DVD Subtitles cannot be turned off when you play a DVDGlossary HS 250 Controller Specifications Harman Consumer Group, Inc