Chamberlain RDO800 manual Program your Opener & Remote

Page 19

10Program your Opener & Remote

Please note your remote controls and wall plate have already been programmed into your operator.

Activate the opener only when door is in full view, free of obstruction and properly adjusted. No one should enter or leave garage while door is in motion. Do not allow children to operate push button(s) or remote(s). Do not allow children to play near the door.

Your garage door opener has already been programmed at the factory to operate with your remote control and wireless wall box.

Fix any wall control at a height of at least 1.5m and within sight of the door but away from any moving parts.

Fix the warning against entrapment label near the wall control.

Program additional Remote Controls:

Using the purple “LEARN” Button

1. Press and release the purple “learn” button on the opener.

or

 

The orange indicator light will glow steadily for 30

 

seconds.

2.

Within 30 seconds, press and hold the desired button on

 

the wireless wall control or remote control that you wish to

 

operate your garage door.

3.

Release the button when the opener light blinks. It has

 

learned the code.

Delete all Remote Control Codes

Please note this deletes all remotes and codes.

Press and hold the PURPLE learn button until the orange indicator light goes out (approximately 9 sec.).

r

e

t

s

a

M

t

f

i

L

11 Setting the Limits

Travel limits regulate the points at which the door will stop when moving up or down. Follow the steps below to set the limits.

Check that the opener is engaged.

To program the travel limits:

1.Press and hold the black button (3) until the orange indicator light (2) starts flashing slowly and then release. Opener lights will dim.

2.Press the BLACK button to move the door UP or the PURPLE button to move the door DOWN until the door reaches the desired UP limit.

Check to be sure the door is high enough for your vehicle. Adjust if necessary.

3.Press the green start button (4). This sets the full UP limit. The door will travel to the floor and reverse back to the UP limit. The opener has learned its travel limits.

4.The indicator light (2) will stop flashing when the limits have been learned.

NOTE: If the door presses excessively on the floor or reverses before it reaches the floor proceed to #12 of the “Troubleshooting” section page 9 and follow the instructions for setting the limits manually.

The force must be learned in order to properly complete the setting of the limits.

1

4

2

3

 

 

 

Manual Limit setting

With the door in the midway position.

Press and hold the black button until the orange LED starts flashing.

Use the black (up) and purple (down) button to set the door opening limit

Press the Green activation button to start the door, once it starts travelling down, press either the black or purple button to engage manual limit setting.

Use the purple and black buttons to set the closing limit.

Test door three or four times to check limit settings.

6

Image 19
Contents Page Tools Required Carton InventoryPrepare Door Install stop bracket collarInstall weight bar Door RequirementsPrepare Opener Place the Opener in Manual Release modeAttaching the Extension Poles if required For Right Hand Installations Refer , Installation stepsTo disengage the opener Attach the Release Handle and CordOperating the Manual Release Pinning the DoorDelete all Remote Control Codes Setting the LimitsProgram your Opener & Remote Testing the Safety Reverse System Setting the ForceInstall the Protector System Safety Beams Accessories Special FeaturesTroubleshooting Opener Light Will Turn On Green start buttonGarage Door Opener Warranty Page Carton Inventory Door Requirements Rope Manual Release Release handle Installation steps Rope Manual Release Release handle Program your Opener & Remote Setting the Force Care of Your Opener Troubleshooting Maintenance of Your Opener 114A3594 C , 2008 Chamberlain GmbH