Carton Inventory, Tools Required | Chamberlain RDO800 specification

The Protector System must be used for all installations where the closing force as measured on the bottom of the door is over 400N (40kgf). Excessive force will interfere with the proper operation of the Safety Reverse System or damage the garage door.

After installation, ensure that the parts of the door do not extend over public footpaths or roads.

Disengage all existing garage door locks to avoid damage to garage door.

Install the wireless wall control (or any additional wall control) in a location where the garage door is visible, at a height of at least 1.5m and out of the reach of children. The appliance is not intended for use by young children or infirm persons without supervision. Serious personal injury from a closing garage door may result from misuse of the opener.

Permanently fasten the Warning Label adjacent to the wall control as a reminder of safe operating procedures.

Activate opener only when the door is in full view, free of obstructions and the opener is properly adjusted. No one should enter or leave the garage while the door is in motion. Do not allow children to play near the door.

Disconnect electric power to the garage door opener before making repairs or removing covers.

SAVE THESE INSTRUCTIONS

Start by Reading These Important Safety Instructions

WARNING: Failure to comply with the following instructions may result in serious personal injury or property damage.

•Read these instructions carefully and follow ALL instructions carefully

•The garage door opener is designed and tested to offer reasonable safe service provided it is installed and operated in strict accordance with the instructions in this manual.

These safety alert symbols mean WARNING – a personal safety or property damage instruction. Read these instructions carefully.

Warning: If your garage has no service entrance door, a 1702E outside quick release must be installed. This accessory allows manual operation of the garage door from outside in case of power failure.

Keep garage door balanced. Do not let the garage door opener compensate for a binding or sticking garage door. Sticking or binding doors must be repaired. Garage doors, door springs, brackets and their hardware are under extreme tension and can cause serious personal injury.

Do not wear rings, watches or loose clothing while installing or servicing a garage door opener.

To avoid serious personal injury from entanglement, remove all ropes, chains and locks connected to the garage door before installing the door opener.

Installation and wiring must be in compliance with your local building and electrical codes.

The safety reverse system test is very important. Your garage door MUST reverse on contact with a 40mm obstacle placed on the floor. Failure to properly adjust the opener may result in serious personal injury from a closing garage door. Repeat the test once a month and make any necessary adjustments.

This opener should not be installed in a damp or wet space.

Take care when operating the manual release since an open door may fall rapidly due to weak or broken springs, or being out of balance.

The drive must not be used on a wicket door (door within a door)

1Carton Inventory

1.Instruction manual (this document)

2.Stop bracket collar

3.Clamp bracket

4.Release handle and cord

5.94335 remote control (2)

6.128LM wireless wall control

7.Extension poles (2)

8.Weight bar

9.Bracket plate

10.Hardware bag

1	Installation and operating instructions
	for rolling door opener Model RDO800

	5	7
	4

8	10
8

2Tools Required

1.Ladder (or similar device to safely support door weight)

2.Adjustable wrench for U-bolts already installed on the door

3.8mm socket, 10mm socket and 13mm extended socket and socket wrench

4.12inch socket extension (for minimum sideroom installations)

5.Drill and 5.5mm drill bit

6.Philips screw driver

7.Marker Pen

13mm, 10mm, 8mm

5.5mm