Chamberlain 1022, 1042, 1024 manual Safety Information

Page 2

SAFETY INFORMATION

OVERVIEW OF POTENTIAL HAZARDS

READ THIS SAFETY INFORMATION

Garage doors are large, heavy objects that move with the help of springs under high tension and electric motors. Since moving objects, springs under tension, and electric motors can cause injuries, your safety and the safety of others depend on the owner or user of this system to read, understand and implement the information in this manual. If you have questions or do NOT understand the information presented, contact The Genie Company or an authorized Genie® Dealer.

The safety alert symbol and following signal words DANGER, WARNING, and CAUTION are used throughout this manual to call attention to and identify different levels of hazard and special instructions.

This is the safety alert symbol. This symbol is placed next to signal words and messages to help you identify important safety information

The word:

DANGER indicates an imminently hazardous situation which, if NOT avoided, will result in death or serious injury.

WARNING indicates a potentially hazardous situation which, if NOT avoided, could result in death or serious injury. CAUTION indicates a potentially hazardous situation which, if NOT avoided, may result in injury or property damage.

The word NOTE is used to indicate important steps to be followed, important considerations, or location of parts.

IMPORTANT SAFETY INSTRUCTIONS

READ AND FOLLOW ALL INSTRUCTIONS

SAVE THESE INSTRUCTIONS

2

POTENTIAL

EFFECT

PREVENTION

 

HAZARD

 

 

 

 

 

 

WARNING:

Keep people clear of opening while door is moving.

 

 

 

 

 

 

Do NOT allow children to play with the door operator.

 

 

 

Could result in Death

 

 

 

Do NOT operate a door that jams or one that has a broken spring.

 

 

 

or Serious Injury

 

 

 

 

MOVING DOOR

 

 

 

 

 

 

 

 

 

 

 

Turn OFF power before removing operator cover.

 

 

 

WARNING:

When replacing cover, make sure wires are not pinched or near

 

 

 

 

 

 

 

Could result in Death

moving parts.

 

 

 

 

 

ELECTRICAL

or Serious Injury

Operator must be properly grounded.

 

 

 

 

SHOCK

 

 

 

 

 

 

 

 

 

 

WARNING:

Do NOT try to remove, install, repair or adjust springs or anything to

 

 

 

 

which door spring parts are fastened, such as, wood blocks, steel

 

 

 

Could result in Death

brackets, cables or other like items.

 

 

 

or Serious Injury

Installations, repairs and adjustments must be done by a trained door

 

HIGH

 

 

 

system technician using proper tools and instructions.

 

SPRING

 

 

 

TENSION

 

 

 

 

 

PN# 3642036534, 02/26/2010 REV. 1

Image 2
Contents Models 1022/1024/1042 Safety Information Safety Features Table of ContentsOpener Features Do not USE AN Extension Cord Typical Sectional Door Installation Recommended Tools Parts Identification Not Shown Full SizeDo not Return to Point of Purchase Chain Piece Rail Hardware Assembled ViewPener Assembly BagRail Assembly for Chain Drive Opener Assembly for Chain Drive Opener Do not move door spring Mounting the header bracket Nstallation Header and Door Mounting BracketsFinding header bracket mounting location Getting started Mounting the assemblyMounting the Opener Install Door Arms Door BracketWall Console Installation Wall Console locationSecurely fasten wires AFE-T-BEAMSYSTEM Installation Mounting Safe-T-BeamSource Red LED and Sensor Green LED3b. Wiring pre-wired ‡ Route Safe-T-Beamwires through wire guideWith Power Supplied Onnecting to PowerWith Permanent Wiring With Grounded PlugOOR Limits Close Travel LimitCarriage Lock Keyed Emergency Release Operation InstructionsUP/DOWN Force TestingAdjustment Erase OPEN/CLOSE Travel LimitRogramming Remote Controls Lost or Stolen RemoteVisor clip Light BULB/LENS InstallationBattery replacement Light bulbDoor balance MaintenanceRoutine Monthly Maintenance Contact reverseCircuit Wiring Diagram Advertencia AvertissementTroubleshooting Guide Operation Problem What to doTroubleshooting Guide Power Head LED Possible Problem SolutionTransmitter Compliance Statement ModelS 1022/1024/1042 Limited Warranty