Things to consider if you are planning to
In many cases you will be replacing an existing door opener with a new one, however, if this will be the first opener installed there are some
The Genie Company recommends that you read and fully understand all information and instructions contained herein before choosing a
(The issue numbers below refer to the circled numbers in the illustrations on page 5.)
1Check your ceiling where the power head of your new unit will be mounted.
Plan how you will be mounting the power head. It is possible that ceiling joists may not be in the position needed with respect to the garage door opener. It may be necessary to add an additional bracket and fasteners (not included with your new door opener kit).
(Refer to Section 2.)
2Check the wall directly above the garage door. The door opener’s header bracket
must be securely fastened to this wall. Insure that the structure will provide a strong mounting location. (Refer to Section 2.)
3Check to see if the mounting location
for the
obstruction and has a wood surface available for attaching the mounting brackets. The brackets may be attached to concrete if necessary but extra tools and special fasteners (not supplied) will be required. (Refer to Section 4 and 5.)
5You need a properly grounded
no more than 3 feet from the power head once it is mounted. (Refer to Section 5.)
WARNING
DO NOT USE AN EXTENSION CORD!
DO NOT USE A PORTABLE GENERATOR! This product is designed to operate on standard house current.
DO NOT USE ALTERNATE POWER SUPPLIES.
6To avoid damage to your door and/or opener, make sure you disable and/or
remove any door locks, ropes, and/or cables (NOT door lift cables) prior to installing your opener. (Refer to Section 1.)
Remove
Remove
7Insure that your door is properly balanced and moving freely. (Refer to Section 2.)
NOTE: Mounting brackets must be installed within code specifications.
4Is your sectional garage door made of aluminum,
or glass panels? Additional support bracing must be added to these type doors. If this is the case, please contact the door manufacturer or authorized dealer so that they can furnish you with a "bracing kit." (Refer to Section 2.)
WARNING
To reduce the risk of injury to persons or damage to property - Use this opener only with sectional doors.
WARNING
If your door jams, binds, is improperly balanced or has a broken spring, have it repaired or adjusted by a trained door system technician. Door springs, cables, pulleys, brackets and associated hardware are under extreme tension and can cause serious injury or death.
8(NOT SHOWN) If your garage does not have a separate entry door, you should consider
an emergency release kit
4 | PN# 3642036534, 02/26/2010 REV. 1 |
|