Chamberlain 1024, 1042, 1022 manual Routine Monthly Maintenance, Door balance, Contact reverse

Page 25

IMPORTANT SAFETY INSTRUCTIONS

WARNING:

Toreduce the risk of severe injury or death:

1.READ AND FOLLOW ALL INSTRUCTIONS.

2.Never let children operate or play with the door controls. Keep the remote control away from children.

3.Always keep the moving door in sight and away from people and objects until the door is completely closed. NO ONE SHOULD CROSS THE PATH OF THE MOVING DOOR.

4.NEVER GO UNDER A STOPPED, PARTIALLY OPEN DOOR.

5.Test opener monthly. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board laid flat) at the center of the doorway on the floor. After adjusting either the force or the limit of travel, retest the door opener. Failure to adjust the opener properly may cause severe injury or death.

6.When possible, use the emergency release only when the door is closed. Use caution when using this release with the door open. Weak or broken springs are capable of increasing the rate of door closure and increasing the risk of severe injury or death.

7.KEEP DOORS PROPERLY BALANCED. See your garage door Owner’s Manual. An improperly balanced door increases the risk of severe injury or death. Have a trained door system technician make repairs to cables, spring assemblies, and other hardware.

8.SAVE THESE INSTRUCTIONS.

If you have any questions, please do not hesitate to contact Genie® customer service at:

1.800.354.3643

10 MAINTENANCE

WARNING

Garage door hardware (springs, cables, brackets, pulleys, etc.) are under extreme pressure and tension.

DO NOT attempt to repair or adjust door springs or any hardware, and DO NOT OPERATE garage door automatically or manually if door is improperly balanced or springs are broken.

CONTACT A TRAINED DOOR SYSTEM TECHNICIAN.

ROUTINE MONTHLY MAINTENANCE

1.Door balance.

With the door closed, pull emergency release knob (Carriage Lock) towards the opener to release door from carriage assembly.

Raise door manually approximately 3'- 4' and release.

Door should remain stationary or move very slightly.

If door moves quickly, CONTACT A TRAINED DOOR SYSTEM TECHNICIAN.

Close the door.

Pull emergency release knob towards door to engage carriage.

Operate door using remote.

Door will re-attach itself to carriage assembly.

2.Contact reverse.

Place a 2" x 4" board laid flat on floor.

In center of garage door opening.

Close door by using wall button or remote control.

Door fails to reverse on contact with board (See section 7 "CONTACT REVERSE.")

Opener still fails

CONTACT THE GENIE COMPANY OR AN AUTHORIZED GENIE® DEALER.

3.Safe-T-Beam®System.

• Red LED blinks.

– check alignment (See section 5 ).

WARNING

Use wall button supplied with opener. Any other wall control can cause the opener to operate unexpectedly.

PN# 3642036534, 02/26/2010 REV. 1

25

Image 25
Contents Models 1022/1024/1042 Safety Information Opener Features Table of ContentsSafety Features Do not USE AN Extension Cord Typical Sectional Door Installation Parts Identification Not Shown Full Size Recommended ToolsDo not Return to Point of Purchase Piece Rail Hardware Assembled View ChainBag Pener AssemblyRail Assembly for Chain Drive Opener Assembly for Chain Drive Opener Finding header bracket mounting location Nstallation Header and Door Mounting BracketsDo not move door spring Mounting the header bracket Mounting the Opener Mounting the assemblyGetting started Door Bracket Install Door ArmsWall Console location Wall Console InstallationSecurely fasten wires Mounting Safe-T-BeamSource Red LED and Sensor Green LED AFE-T-BEAMSYSTEM Installation‡ Route Safe-T-Beamwires through wire guide 3b. Wiring pre-wiredWith Permanent Wiring Onnecting to PowerWith Power Supplied With Grounded PlugClose Travel Limit OOR LimitsKeyed Emergency Release Operation Instructions Carriage LockAdjustment TestingUP/DOWN Force Erase OPEN/CLOSE Travel LimitLost or Stolen Remote Rogramming Remote ControlsBattery replacement Light BULB/LENS InstallationVisor clip Light bulbRoutine Monthly Maintenance MaintenanceDoor balance Contact reverseAdvertencia Avertissement Circuit Wiring DiagramProblem What to do Troubleshooting Guide OperationPossible Problem Solution Troubleshooting Guide Power Head LEDTransmitter Compliance Statement ModelS 1022/1024/1042 Limited Warranty