Shark S3251 manual Using Your Light & Easy Steam Mop, Reference the troubleshooting section

Using Your Light & Easy™ Steam Mop

	When you use your steam mop for the
	first time or if you have not used the unit
	in awhile, it may take a minute or two
	for the water to travel through the pump
	and into the heater to create steam. Get
	it started by pumping the handle a few
	times. If you have waited a few minutes
	and you still do not see any steam,
fig. 1	reference the troubleshooting section
	on page 10.

fig. 2

fig. 3

IMPORTANT: Your steam mop needs water to make steam! Never use your steam mop without water in the tank.

Sweep or vacuum your floors prior to cleaning with your Light & Easy™ Steam Mop.

Visit www.sharkclean.com for other great quick cleaning products to complement your Light & Easy™ Steam Mop, such as the Shark® Navigator.

1Pull and twist the quick release cord holder to unwrap the power cord completely. (fig. 1) Plug into a 120-volt electrical outlet. (fig. 2) The “On” light will turn blue. If the light does not turn on, reference the troubleshooting section on page 10. (fig. 3)

6

TOLL FREE: 1-800-798-7398

S3251_11_ENG_IB_101117.indd 6 10-11-17 1:58 PM