Harman-Kardon AVR 3550HD Audio/Video Inputs, Digital Audio Inputs, Outputs, Ease of Use

Page 6

INTRODUCTION

Audio Inputs

•AM/FM/XM®* tuner

•Analog Audio 1 through 5 (assignable)

•Front-panel Analog Audio (assignable)

•6-/8-Channel Analog Audio (assignable)

Audio/Video Inputs

•Three Analog Video (assignable)

•Front-panel Analog Video (assignable)

•Three Component Video 100MHz (assignable)

•Three HDMI™ (V.1.3 with Deep Color and audio/video processing)

•Faroudja DCDi Cinema™ video processing

Transcodes composite and S-video to component video

Transcodes 480i video to component video format, with upscaling to 1080i

Transcodes 480i video to HDMI output, with upscaling up to 1080p

• for iPod** connectivity with audio/video playback

Digital Audio Inputs

•Coaxial: two rear-panel/one front-panel

•Optical: three rear-panel/one front-panel

Outputs

•7.1-Channel preamp outputs

•Analog Audio 2 and 4

•Analog Video 2

•Video monitor (composite, S-video and component)

•Digital audio (one coaxial)

•HDMI (V.1.3a with Deep Color)

•Multizone audio: speaker- and two line-level (one dedicated, one shared with surround back channels)

•A-BUS®Port

•Headphone

Ease of Use

•EzSet/EQ™ automated setup (microphone supplied)

•Full-color user interface and setup menu, generated in high-definition video

•Two-line dot-matrix front-panel display

•Color-coded connections

•Programmable, learning 7-device main remote control (includes AVR control over The Bridge II)

•Source input renaming

•Lip Sync Delay (up to 180msec)

•RS-232 serial port for system upgrades

•Switched accessory power outlet

•Remote infrared (IR) input and output

•Zone 2 IR input, Carrier IR Output and A-BUS IR Output

•IEC detachable AC power cord for easy installation

Supplied Accessories

The following accessory items are supplied with the AVR 3550HD. If any of these items are missing, please contact Harman Kardon customer service at www.harmankardon.com.

•System and Zone 2 remote controls

•EzSet/EQ microphone

• docking station for iPod

•AM loop antenna

•FM wire antenna

•Six AAA batteries

•Two covers for front-panel jacks

•AC power cord

*XM antenna module and subscription to XM service required. Hardware and service sold separately. XM service is not available in Alaska or Hawaii.

**Compatible with most docking iPod models, 4G and later. Video and still-image viewing requires an iPod that supports video browsing.

6

6

Image 6

Contents AVR 3550HD Safety Information Important Safety InstructionsImportant Safety Information Do not place the unit directly on a carpeted surfaceTable of Contents Thank you for choosing a Harman Kardon product IntroductionHarman Kardon AVR 3550HD 7.1-Channel Audio/Video Receiver Audio SectionAudio/Video Inputs Supplied AccessoriesAudio Inputs Digital Audio InputsFRONT-PANEL Controls Power Indicator This LED has three possible modes On When the AVR is turned on, this LED turns whiteVolume Knob Turn this knob to raise or lower the volume REAR-PANEL Connections REAR-PANEL Connections REAR-PANEL Connections Main Remote Control Functions Main Remote Control Functions Main Remote Control Functions Zone 2 Remote Control Functions Zone 2 Remote Control Functions Typical Home Theater System Introduction to Home TheaterSurround Modes Multichannel AudioSpeaker Connections Connecting Source Devices to the AVRConnections SubwooferAnalog Video Video ConnectionsDigital Video Hdmi cable runs are limited to about 10 feetFM antenna uses a 75-ohm F-connector. See Figure AntennasRS-232 Serial Port Placement of Surround Speakers in a 5.1-Channel System Speaker PlacementFront Speaker Placement Placement of Surround Speakers in a 7.1-Channel SystemStep Two Connect the Subwoofer InstallationStep One Connect the Speakers Step Three Connect the AntennasChoose one digital audio connection Optical or Coaxial Audio Connections for non-HDMI sourcesVideo Connections for non-HDMI sources Hdmi Video Connect the player as shown in FigureConnect an Audio/Video Recorder PVD, DVR or TiVo Hdmi Video Connect the recorder as shown in FigureConnect a CD Player or Any Audio-Only Device Connect an iPod Using Docking StationConnecting a Game Console, Camera or Other Device Connect a Tape Deck or Any Audio-Only RecorderStep Six Plug in AC Power Step Five Connect the Video DisplayStep Seven Insert Batteries in Remote Enter a code from , aboveSatisfactory code set that operates most functions Step Ten Install a Multizone System Optional LearningStep Eleven Turn On the AVR 3550HD Zone 2 Audio OutputsAVR Power On and Source Selectors Initial Setup Using the On-Screen Menu SystemConfigure the AVR 3550HD Using EzSet/EQ Technology Set Up Sources Select Cancel to return to the Speaker Setup menuAudio and Video Input Selection Channel Direct InputsHDMI-Equipped Multichannel Disc Player ‹ / › Buttons to delay the audio by up to 180ms. See Figure You are now ready to begin enjoying your new receiverOperation Using the Tuner Source SelectionXM Radio Operation Press the OK Button to store the new preset Using Docking StationTo store a channel in one of the 40 preset locations RecordingSelecting a Surround Mode Press the Menu Button to view the slide-out menuMusic Navigates the audio materials stored on the iPod CH Stereo plays the left-channel signal through the front Auto SELECT, Surr VIRTUAL, Surr STEREO, Surr MOVIE, SurrAdvanced Functions Analog Audio SignalsDigital Audio Signals Audio Processing and Surround SoundDolby Surround Settings Indicates that no surround information is presentNight Mode Manual SetupStep Three Manual Setup Menu Step Two Measure Speaker DistancesAdjust Crossover Frequencies Menu Sub ModeNumber of Speakers Step Four Setting Channel Output Levels Manually Adjust Speaker Distance MenuVideo Adjustments Tone Control Determines whether the treble and bassNature For programs shot outdoors, in a natural setting How to Adjust the Custom Picture SettingsBrightness Adjustment Sports For sporting eventsMultizone Operation Operating the Multizone System System SettingsGeneral AVR Settings Menu AppearancePunch-Through Programming Advanced Remote Control FunctionsResetting the Remote Activities MacrosProcessor Reset MemoryTroubleshooting Guide Appendix Appendix Default settings, worksheets, remote product codesTable A2 Source Setting Defaults Table A1 Recommended Source Component ConnectionsTable A3 Speaker/Channel Setting Defaults Table A4 Delay Setting DefaultsTable A5 Source Settings Table A6 Audio Effects SettingsTable A7 Video Modes Settings Table A9 Remote Control Codes Table A10 System SettingsTable A8 Surround Modes Table A11 Zone 2 Settings Table A12 Surround ModesMovie Back channel 0 or .1, EX Analog 2-channel Tuner Mode Group Enveloping sound field is desiredExperience Tuner Music adds a surround back channel Analog 2-channel TunerPerformance Via Hdmi DTS-ES Matrix Surround Mode Description Incoming Bitstream or SignalRate used on DVD-Video discs DTS StereoChannels Tuner PCM 32kHz, 44.1kHz or 48kHz Channel Stereo Appropriate when a subwoofer is usedChannel Stereo Analog Bypass41 42 Table A13 Remote Control Function List RadioDMC1000 Button Name Power OffTable A13 GameAiwa Table A14 Table A16 Remote Control Product Codes AUX-VCRTable A15 Remote Control Product Codes AUX-HDTV Table A16Table A18 Remote Control Product Codes DVD Table A17Table A19 Remote Control Product Codes SAT Table A20 Remote Control Product Codes GameTable A21 Remote Control Product Codes CBL Table A24 Remote Control Product Codes AUX- TiVo Table A22 Remote Control Product CodesTable A23 Remote Control Product Codes Table A21Product Shipping Weight 31.5 lb 14.3kg 36.7 lb 16.7kg General Power Requirement AC 120V/60Hz Power ConsumptionChannels driven Dimensions Product Shipping Width Linear High-Level 200mV/47k ohms