Bissell 18Z6 warranty Unplug cleaner from electrical outlet, Pulley

Page 12

Maintenance and care

Rotating brush and drive belt maintenance

Check your vacuum cleaner’s rotating floor brush and drive belt regularly for debris, wear or damage. Debris can wrap around the brush and hamper its ability to effectively clean your carpet.

1.Unplug cleaner from electrical outlet.

2.Remove detachable canister from vacuum cleaner

3.Recline handle and turn vacuum cleaner over so bottom side is up.

4.Remove the six screws as shown with a Phillips head screwdriver. Lift the brush cover off.

5.Lift the rotating floor brush to remove. Clean strings, hair and other debris from the brush, paying special attention to the brush ends.

6.Check air passageway for obstructions. Remove any debris from this area.

7.Clean debris from the motor pulley and drive belt areas.

8.Check drive belt carefully for wear, cuts or stressed areas. If any damage is present, discard old drive belt and replace.

9.Place one end of the new drive belt over motor pulley and the other end over the brush in the space between the bristles.

10.Pull the brush firmly to stretch the drive belt and place ends of brush down into slots on sides as shown. Turn brush several times by hand to center the drive belt.

11.Reposition brush cover and screws. Tighten screws securely.

Caution:

To reduce the risk of injury from moving parts, turn off vacuum cleaner and disconnect Power Plug from electrical outlet.

4.

 

6.-8.

Motor

Air

Pulley

Passageway

Drive Belt

10.

12 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5

Page 11 Page 13
Image 12
Page 11 Page 13
Contents
Warranty E R ’ S G U I D EThank you for buying a Bissell Lift-OffMultiCyclonic vacuum Important Safety Instructions Product view How to use this guide AssemblyAttach handle to vacuum Attach vacuum hose and toolsPower switch/brush switch OperationHandle position Pet TurboBrush snaps on to the holderPower height adjustment Special toolsPlace handle in upright position Length of the strap may be adjusted as required for comfort Shoulder Strap select models onlyPower cord storage Transporting CleanerTurn vacuum cleaner off O Loop power cord around cord wraps on side of the canisterMaintenance and care Empty dirt containerReplace the Hepa media post-motor filter every six months Empty dirt into garbage containerCleaning the pre-motor and post-motor filter Unplug the cleaner from electrical outletUnplug the vacuum from electrical outlet Unplug cleaner from electrical outlet Clean debris from the motor pulley and drive belt areasPulley TurboBrush maintenance Replace light bulbReposition lens and secure with the one screw Unplug vacuum from electrical outletCleaning clogs Turn the cleaner OFF O and unplug from electrical outlet Thermal protectorRefer to the Clearing Clogs section Troubleshooting Vacuum cleaner won’t runVacuum cleaner is difficult to push Visible dirt escaping from cleaner Authorized service representativePossible causes Remedies Bissell consumer service M. 10 p.m. ETSaturday StyleWarranty Limited Three Year WarrantyIf your Bissell product should require service
Related manuals
Manual 20 pages 28.87 Kb