Bissell 18Z6 warranty Cleaning the pre-motor and post-motor filter

Page 11

Maintenance and care

Cleaning the secondary cyclone

1.

Unplug the cleaner from electrical outlet.

1.The secondary cyclone can be reached by removing the dirt container, reaching underneath the upper tank and turning the rim of the frame to unlock. Pull straight down to remove.

2.The cyclone and screen may be separated for cleaning. Simply pull up on the screen to separate.

3.The upper tank may also be wiped clean with a damp cloth.

Cleaning the pre-motor and post-motor filter

1.Unplug the vacuum from electrical outlet.

2.The Pre-Motor Filter protects the motor from dirt particles. It is located in the slide out tray underneath the Dirt Container. If the filter becomes dirty, pull out the tray, lift out the filter and clean. This filter may be hand washed in cold water with mild detergent. Rinse well and air dry thoroughly before replacing.

3.The HEPA Media Post-Motor Filter assists in the filtration process to return clean air to the room. It is located behind the door on the back of the cleaner. If the filter becomes dirty, open the door, remove the filter and replace. The HEPA Media Filter is not washable.

2.

Pre-Motor Filter

3.

HEPA Media

Post-Motor Filter

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5

11

Image 11 Contents
E R ’ S G U I D E WarrantyThank you for buying a Bissell Lift-OffMultiCyclonic vacuum Important Safety Instructions Product view Attach vacuum hose and tools How to use this guideAssembly Attach handle to vacuumPet TurboBrush snaps on to the holder Power switch/brush switchOperation Handle positionPlace handle in upright position Power height adjustmentSpecial tools Shoulder Strap select models only Length of the strap may be adjusted as required for comfortLoop power cord around cord wraps on side of the canister Power cord storageTransporting Cleaner Turn vacuum cleaner off OEmpty dirt into garbage container Maintenance and careEmpty dirt container Replace the Hepa media post-motor filter every six monthsUnplug the vacuum from electrical outlet Cleaning the pre-motor and post-motor filterUnplug the cleaner from electrical outlet Pulley Unplug cleaner from electrical outletClean debris from the motor pulley and drive belt areas Unplug vacuum from electrical outlet TurboBrush maintenanceReplace light bulb Reposition lens and secure with the one screwCleaning clogs Refer to the Clearing Clogs section Turn the cleaner OFF O and unplug from electrical outletThermal protector Vacuum cleaner is difficult to push TroubleshootingVacuum cleaner won’t run Possible causes Remedies Visible dirt escaping from cleanerAuthorized service representative M. 10 p.m. ET Bissell consumer serviceStyle SaturdayIf your Bissell product should require service WarrantyLimited Three Year Warranty
Related manuals
Manual 20 pages 28.87 Kb