Bissell 18Z6 warranty How to use this guide, Assembly, Attach handle to vacuum, Vacuum body

Page 5

How to use this guide

This user’s guide has been designed to help you get the utmost satisfaction from your BISSELL vacuum. You’ll find assembly and operating instructions, safety precautions, as well as maintenance and troubleshooting instructions. Please read this guide thoroughly before assembling your vacuum cleaner.

Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Following this user’s guide will greatly enhance your ability to get the most performance from your BISSELL vacuum for many years.

Warning:

Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.

Assembly

The only tool you’ll need to assemble your vacuum cleaner is a Philips head screwdriver.

Attach handle to vacuum

2.

 

 

1.

Locate the vacuum handle and remove the

 

 

 

 

screw packet taped to the base of the handle.

 

 

 

 

 

 

 

2.

Stand the vacuum upright and slide the base

 

 

 

 

of the handle firmly into the grooves at the top

4.

 

of the vacuum body.

 

 

 

 

3.Check to be sure the handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly until the handle is flush.

4.Insert the two screws from the screw packet into the existing holes. Tighten securely with a screwdriver.

Attach vacuum hose and tools

1.

 

1.Position the Twist ‘n Snap Hose™ assembly on the vacuum and line up the tabs on the base of the hose with the corresponding notches. Turn the Twist ‘n Snap Hose to the right to lock into place.

2. Slide the end of the hose grip onto the hose

2.

 

grip base. Place the hose into the hose clip.

 

NOTE: The powerfoot will not operate effectively unless the hose is firmly attached to the base.

w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5

5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents
E R ’ S G U I D E WarrantyThank you for buying a Bissell Lift-OffMultiCyclonic vacuum Important Safety Instructions Product view Assembly How to use this guideAttach handle to vacuum Attach vacuum hose and toolsOperation Power switch/brush switchHandle position Pet TurboBrush snaps on to the holderPlace handle in upright position Power height adjustmentSpecial tools Shoulder Strap select models only Length of the strap may be adjusted as required for comfortTransporting Cleaner Power cord storageTurn vacuum cleaner off O Loop power cord around cord wraps on side of the canisterEmpty dirt container Maintenance and careReplace the Hepa media post-motor filter every six months Empty dirt into garbage containerUnplug the vacuum from electrical outlet Cleaning the pre-motor and post-motor filterUnplug the cleaner from electrical outlet Pulley Unplug cleaner from electrical outletClean debris from the motor pulley and drive belt areas Replace light bulb TurboBrush maintenanceReposition lens and secure with the one screw Unplug vacuum from electrical outletCleaning clogs Refer to the Clearing Clogs section Turn the cleaner OFF O and unplug from electrical outletThermal protector Vacuum cleaner is difficult to push TroubleshootingVacuum cleaner won’t run Possible causes Remedies Visible dirt escaping from cleanerAuthorized service representative M. 10 p.m. ET Bissell consumer serviceStyle SaturdayIf your Bissell product should require service WarrantyLimited Three Year Warranty
Related manuals
Manual 20 pages 28.87 Kb