Bissell 18Z6 warranty Cleaning clogs

Page 14

Maintenance and care

Cleaning clogs

4.

Low suction or poor pickup may be due to a clog in the vacuum cleaner. If you notice a change in the sound of the motor or a reduction in the spinning action, check for clogs.

1.Unplug cleaner from electrical outlet.

2.Empty Dirt Container.

3.Check Upper Tank for build up or clogs.

4.Remove the secondary cyclone and check the suction inlet for a clog.

5.Grasp the Hose Grip and lift to separate from the suction opening. Check for a clog in the Base or the Hose.

6.Release the Twist n' Snap hose from the vacuum by turning to the left. Straighten the hose and unclog with a long, narrow object such as a broomstick.

7.If the low suction persists, follow the instructions for Checking the Rotating Brush on page 11 and inspect the Air Passageway for obstructions.

Suction

Inlet

5.

Suction

Opening

7.

Air Passageway

14 w w w . b i s s e l l . c a

1 - 8 0 0 - 2 6 3 - 2 5 3 5

Page 13 Page 15
Image 14
Page 13 Page 15
Contents
Warranty E R ’ S G U I D EThank you for buying a Bissell Lift-OffMultiCyclonic vacuum Important Safety Instructions Product view Attach handle to vacuum How to use this guideAssembly Attach vacuum hose and toolsHandle position Power switch/brush switchOperation Pet TurboBrush snaps on to the holderPlace handle in upright position Power height adjustmentSpecial tools Length of the strap may be adjusted as required for comfort Shoulder Strap select models onlyTurn vacuum cleaner off O Power cord storageTransporting Cleaner Loop power cord around cord wraps on side of the canisterReplace the Hepa media post-motor filter every six months Maintenance and careEmpty dirt container Empty dirt into garbage containerUnplug the vacuum from electrical outlet Cleaning the pre-motor and post-motor filterUnplug the cleaner from electrical outlet Pulley Unplug cleaner from electrical outletClean debris from the motor pulley and drive belt areas Reposition lens and secure with the one screw TurboBrush maintenanceReplace light bulb Unplug vacuum from electrical outletCleaning clogs Refer to the Clearing Clogs section Turn the cleaner OFF O and unplug from electrical outletThermal protector Vacuum cleaner is difficult to push TroubleshootingVacuum cleaner won’t run Possible causes Remedies Visible dirt escaping from cleanerAuthorized service representative Bissell consumer service M. 10 p.m. ETSaturday StyleIf your Bissell product should require service WarrantyLimited Three Year Warranty
Related manuals
Manual 20 pages 28.87 Kb