GE GXRV10ABL01 owner manual Option D

Step-by-step installation instructions.

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

Filtration Drain Connection Installations

Secondary Recommendation

(Use only if option A, B or C on page 13 is not possible.)

OPTION D.

DRAIN LINE ADAPTER INSTALLATION (Fig. 3D)

DO NOT install the drain line downstream of a disposal or in a horizontal pipe. Install the provided drain line adapter under the sink as shown.

The baffle-tee or y-connector shown must be in place (purchase and install if necessary) to prevent a clog in the Reverse Osmosis drain line. Route the drain line from the air gap to the drain line adapter ensuring that there are no dips, loops or low spots in the line, which could result in a clogged drain line. The drain line adapter should be aligned vertically so that the hose connection points in a direction 45°off vertical. (See Fig. 3E.) This installation MAY result in a slight drain noise in the sink drain when the Reverse Osmosis system is operating. Rotate the Drain Line adapter tee assembly slowly until noise is minimized. Generally, 180° opposite the existing horizontal pipe/baffle-tee is a good orientation.

CAUTION!

DO NOT INSTALL DRAIN LINE ADAPTER

DOWNSTREAM FROM DISPOSER.

When installed, the tubing must not have any dips, kinks, loops, etc. The tubing must be cut to length to provide a straight routing from the faucet to the drain (Fig. 3F). See instructions in the “Filtration Drain Connection Installation” section for details and options.

INCORRECT INSTALLATION WILL RESULT IN WATER BACK-UP IN THE DRAIN LINE, WHICH WILL LEAK AT THE FAUCET!

Fig. 3F.

Disposer

Drain line is straight

Drain line adapter

HOT COLD

Drain line adapter in different line from disposer

Fig. 3D.

	From faucet air gap
Mandatory baffle-tee	Drain line
or y-connector	adapter
From second
sink or disposer	Drain line connection should be 180°
	opposite existing horizontal
	pipe/baffle-tee as shown in diagram

Fig. 3E.

Proper drain line adapter orientation.

45°

Drain line adapter

14